Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
On grease seals the TB means a low pressure, double lip seal with a spring and the VB means a non-pressure, single lip seal without a spring. The seal you will need for the part #171255TB is the TruRyde Grease Seals-Double Lip, part #RG06-050. This…
view full answer...The seal that you need to replace your Transcom grease seal TCM 171255VB are the TruRyde Grease Seals #RG06-050. These are a double lip seals that are sold by the pair, so you will need to order 2 sets to get 4 total seals .
view full answer...Currently Kodiak only manufacturers the 12" Hub-and-Rotor Assembly #KHR12D with a Dacromet coating and is not available in stainless steel. They do offer their Kodiak Disc Brake Kit #K2R526S which you will be able to use with a pair of…
view full answer...The P-15 model information you provided for your Dexter axle does indicate its model, but you will still need to note its length and capacity before locating the correct replacement. If you are able to find a longer serial number somewhere on the…
view full answer...The correct replacement bearing kit for a 6,000 lb Dexter axle is the following: - Bearing Kit #BK3-100 This comes with the correct replacement bearings, races, and seal for one hub, so you'd need a quantity of two bearing kits for one axle.
view full answer...Starting with the axles, we do not carry any galvanized axles in the dimension you are needing. You may consider taking the axles you already have and having them galvanized at a local facility as long as they are not otherwise damaged. While we do…
view full answer...Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…
view full answer...The part number "TCM22333TBN" that you referenced on your grease seal cross-references to the Grease Seals 10-36 part #RG06-070. If you need any other parts for your trailer hubs i.e. bearings or races, I would need to know either the part…
view full answer...The Spindle Grease Seal Set, part #BB60011, can be used on an EZ Lube Spindle provided you have correctly matched the seal and spindle dimensions. The best way to determine what seals would work for you is to match your existing seals based on their…
view full answer...Selecting a replacement electric drum brake assembly requires you to match a few characteristics of your existing assembly. The Dexter brake you referenced, part #23-106, is a 12 x 2-inch right-hand (passenger side) electric brake with a 5-bolt…
view full answer...The inner diameters of the LM67048 and 15123 both are the same (1.250 inches). That means that a hub with either bearing in the outer bearing would fit your spindle. The part #AKHD-655-6-EZ-K would fit your axle.
view full answer...First you will need to remove the old hydraulic equipment. Remove the surge coupler or actuator, remove all the lines, and finally remove the brake assemblies. If you have 10 inch diameter hub and drums, you may need to replace those as well. If you…
view full answer...Related Searches
Filter Your Search
Contact and Help