Thanks for getting me all the info needed to pick out a hub! Based on what you listed the correct hub you need for a replacement is the part #84545BX. This uses the same bearings as what you have and has a matching bolt pattern.
Hey Clint, the Dexter Heavy-Duty Suspension Kit for Tandem-Axle Trailers #K71-449-00 that you referenced would work really well for you. The equalizers are the same dimensions and the shackle straps are close enough to what you have that they would…
The D52 on your axle tag means it is a 5,200 lb axle. For a kit that has all of the bearings and seal for your Dexter D52 5,200 lb axle you'd want the kit part #BK3-310 and then for a spindle nut you'd want the #165686. Aside from that the…
The Prime Guard Wheel Bearing Hi-Temp Red Grease part #L11380 16-oz tub will be enough to pack the wheel bearings and grease the spindle on your travel trailer. I have attached a helpful article for your reference about packing the bearings. The…
The Dexter Trailer Brake Assemblies 023-466-00 and 023-467-00 will cross-reference to our Dexter Nev-R-Adjust Electric Trailer Brake Kit part #23-458-459.
I suggest the Advent Air RV Air Conditioner w/ Air Distribution Box and Start Capacitor, #ACM135C. This is a 13,500 Btu ductless air conditioner that has a distribution box with built-in thermostat to control the fan and temperature and a start…
Hey Pete, thanks for all of the info you mentioned on your current equalizer setup. Based on that you can use the Dexter Heavy Duty Suspension Kit part #K71-449-00 that you asked about with the included shackles that are 2-1/4 inch. The slightly…
Hello again Dave; the Dexter Heavy-Duty Suspension Kit for Tandem-Axle Trailers #K71-449-00 may fit your trailer but you will need to measure to be sure. When you replace shackle straps and equalizers you want them to match what you already have so…
Based on the dimensions you have provided the best fit would definitely be the Dexter Heavy-Duty Suspension Kit for Tandem-Axle Trailers - 1-3/4" Wide Double-Eye Springs #K71-449-00. These equalizers are an exact match for your current…
Generally you'll want to replace your equalizer and shackles with ones that have the same or similar dimensions. The equalizer in the #AP233 kit has a 2" tall and 5-3/4" long (eye bolt center to eye bolt center) and the shackles…
The lengths of the shackles that come with the equalizer kit part #K71-449-00 that you referenced are 2-7/8 inches measured from hole center to hole center. If yours are currently 3-1/8 inches this change would slightly lower the height of the…
The 1/4 inch shackle strap difference With the Dexter Heavy-Duty Suspension Kit, Item #K71-449-00, will make a slight difference but should not be a problem. I certainly would not go with anything that is greater than 1/4 inch difference. The…
Filters
