Do Lippert ABS Brake Assemblies For Trailers Come With ABS Sensor Already Installed?
Published 08/12/2025 >
Question:
Do these brakes come with the ABS sensors already installed, or do I have to transfer them from my old ones?
asked by: Mike
Expert Reply:
Mike, good news these # LC73PX brake assemblies come with the integrated sensors already built in. They’re purpose-built to replace worn-out brakes on trailers with the Lippert ABS system, so no retrofitting needed. Just bolt them up, install the abs sensors, connect your wires, and you’re good to go.
Do your current hubs already have the ABS ring? If not, let me know so we can make sure you grab the right replacement hubs too.
Product Page this Question was Asked From
Electric Trailer Brake Assembly for Lippert ABS Hubs - 10" - Left/Right Hand - 3,500 lbs
- Trailer Brakes
- Electric Drum Brakes
- Standard Grade
- ABS
- Self Adjust
- 10 x 2-1/4 Inch Drum
- 3500 lbs Axle
- 13 Inch Wheel
- 14 Inch Wheel
- 15 Inch Wheel
- Lippert
more information >
Continue Researching
- Search Results: rv bumper racks
- Video: Review of Lippert Electric 10 Inch Right Hand Trailer Brake Assembly ABS Hub - LC42NX
- Q&A: How Does Lippert ABS Trailer Brakes Get Wired And Programmed On Trailer With Anti Lock Brakes?
- Shop: Electric Trailer Brake Assembly for Lippert ABS Hubs - 10" - Right Hand - 3,500 lbs
- Shop: Trailer Wiring
- Shop: Curt T-Connector Vehicle Wiring Harness with 7-Way Trailer Connector
- Shop: Electric Trailer Brake Assembly for Lippert ABS Hubs - 10" - Left/Right Hand - 3,500 lbs
- Shop: Trailer Hub and Drum Assembly for Lippert ABS System - 3.5K Axles - 10" - 5 on 4-1/2
- Shop: 24x40 etrailer Cargo Carrier for RV Bumper - Steel - Folding - 500 lbs
- Shop: 24x60 etrailer Cargo Carrier for RV Bumper - Steel - Folding - 500 lbs
- Shop: Replacement Wiring Harness for Lippert Ground Control 3.0 RV Landing Gear - Front Driver's Side
- Q&A: Replacement for Lippert 126003 Hub and Drum Assembly
- Q&A: Can I Get MORryde Suspension Upgrade Kit MR86ZR With Two Extra Sets Of Shackle Straps?
- Q&A: Replacement Hub for a Lippert LCI 126003 Hub
- Q&A: Replacement Brakes And Hubs For A 3,500 Pound Lippert Hub 126003
- Q&A: Replacement Brakes And Drums For A 7k Rated Sloan Kwik Load Trailer
- Q&A: What Bearing Kit do I Need for My Lippert 3,500 Pound Axle with Serial Number S007855123?
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Charge a Dump Trailer Battery
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Measure a Trailer Axle
- Article: Trailer Wiring Diagrams
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: How to Tell the Weight Rating of a Trailer Axle

