Trailer Hitch And 7 Pin Wiring Setup For A 2008 Chevy Uplander

Published 09/19/2023

Products Featured in This Question

T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(108)

$40.06

Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"

(51)

$222.75

Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"

(53)

$225.08

Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional

(6643)

$169.94

Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires

(3397)

$121.25

Question:

Have a car hauler with electric brakes and battery. Just bought a 2008 Chevy Uplander work van. Need class III hitch, and wiring/ brake controller set up. 7 pin round plug. Please advise. And where is the plug in if there is one ?

asked by: Donald S

Expert Reply:

We can definitely set you up. For a trailer hitch for your 2008 Chevy Uplander we do have a no drill option # 13336. This will only fit models with the 121" wheel base. If you do not have the 121" wheel base I recommend the # 13344, which will require some drilling. Both hitches are rated for 4,000 lbs towing and 400 tongue weight.

For your 7 pin round plug trailer wiring and brake controller, you will need the following parts.

T-One Wiring Harness # 118396
Universal Install Kit # ETBC7
Prodigy P3 Brake Controller # 90195

The 4 pin harness will plug in behind your tail lights on each side. The universal install kit will include all of the wires needed to install the brake controller. I have linked a few of our install videos below if you want to get a better idea of the process.