Will Optronics Trailer Taillight # STL008RB Fit Peterson Light Mounting Brackets
Published 08/24/2023
Products Featured in This Question
Question:
Need an L-shaped bracket to mount these on side of trailer. Are these compatible with Peterson mounting brackets? What would work?
asked by: Wyatt
0
Expert Reply:
If you have Peterson lights currently that look like the Optronics taillights part # STL008RB then the mounting brackets you have now will work just fine as these were made to be basically an exact replacement.
We don't have any L-brackets though but instead you could go with the CE Smith trailer tail light protector part # CE26051A to mount it to your trailer.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
ONE LED Trailer Tail Light - 6 Function - Submersible - Square - Red Lens - Passenger Side
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Marker
- Square
- Surface Mount
- Submersible Lights
- LED Light
- 5-1/16L x 4-9/16W Inch
- Red
- Optronics
more information >
Continue Researching
- Q&A: Availability Of 2" Long 1/2" Wheel Stud With 0.56" Spline
- Q&A: Replacement Brake Actuator for Global Direct GDC-80
- Q&A: What Size Cut Out For Recessed Led Light
- Q&A: How Many Amps Does the Breaker Need to be When Installing the Furrion Chill 15000 BTU Unit
- Q&A: Looking For Hub With 68149 Inner And 67048 Outer Bearings
- Q&A: 5-Lug Trailer Hubs With Inner Bearing L68149 & Outer Bearing L44649 for Boat Trailer
- Q&A: Trailer Wiring Harness Recommendation for a 2006 Jeep Wrangler Unlimited LJ
- Article: Gooseneck vs Fifth-Wheel Trailers
- Article: Trailer Wiring Diagrams
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: Basics of Tie-Down Anchors
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)