Review of the Optronics LED Combination Trailer Tail Lights Video

With the 1/2 inch diameter wheel studs on your etrailer.com Idler Hub Assemblies #AKIHUB-545-35-K and the 15 inch steel wheels from the Loadstar Tire and Wheel #AM3S640DX, you are looking at a torque spec of 90-120 ft.-lbs for the lug nuts. I have…

We do offer a wide variety of replacement lights for trailer but since trailer manufacturers don't keep a record of what they use on trailers I would need some pictures of the lights you are wanting to replace along with some measurements so I…

I wasn't able to track down any information on the particular Bargman breakaway switch that you have so your best option is going to be to simply replace the switch assembly. Cables and pins/plungers are pretty specific to the models they are…

Yes, the Peterson LED Trailer Tail Lights Driver #PE27RV and Passenger #PE87RV will replace your Shore Land'r 5110570 and 5110569 tail lights. Rather than reusing the push connect wiring from your current tail lights I recommend picking up…

The majority of our brake line fittings are made from brass which are a bit different than the steel brake line fittings you might be familiar with on a passenger vehicle. Generally speaking, the cause of these brass brake line fittings leaking is…

Hey Kevin, welcome back. The CE Smith Multi Sport Boat and Kayak Trailer item #CE48810 uses NLGI #2 water-resistant marine-grade grease like item #L54FR. The brand isn't listed. The LubriMatic Marine Trailer Wheel Bearing Grease item #L54FR is a…

Going by the colors that you mentioned, it sounds like you have the typical set-up, green wire for right turn and brake, white wire for ground, yellow wire for left turn and brake, brown with green wire for right side running lights, and brown with…

The Over 80", Rectangular Submersible Trailer Tail and License Light #ST17RB that you referenced is an exact replacement for the Wesbar 3504 light you have so it would work perfectly for you.

The correct replacement taill light you need is the part #403026 which can easily be wired to what you have now. The white wires will match from where the white wire of your old assembly ran, the red wire will be the stop/turn circuit and the black…

The older generations of the Wesbar submersible low-profile lights came with sealed light bulb capsules that are not replaceable. If your capsule is sealed, then your best option is to replace the lights with new lights like part #403026 and #403076.…

I believe I have a solution for you, but the SAE number you listed isn't a reliable way to get a replacement lens. Based on the picture you submitted (thank you for that by the way), it looks like you are in need of a part #A39RB. This lens…

Optronics does make a LED light that is close to the same size as the, #MC32AB. Check out the Sealed, Rectangular LED Trailer Clearance and Side Marker Light, #MCL49AB. I have also provided a link to a video review showing this light in action. If…