Best Replacement For Pollak 30 Amp Circuit Breaker

Question

Question:

I have a travel trailer with a Pollak circuit breaker stamped 12V Y24 30A. Which replacement 30A breaker is the best replacement?

asked by: Brian K

0

Expert Reply:

The best replacement for your Pollak 30 amp circuit breaker is the Pollak Circuit Breaker - Cycling/Automatic Reset - 30 Amp - Straight Mount Bracket # PK54530.

expert reply by: Kyle S

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 5

Thanks for your question, Peter! I do have one question before I can point you to the correct kit. What is the year, make, and model of your RV? The reason I ask is that if your RV already has an air fitting at the rear bumper, there’s a chance it…

view full answer...

Answer 6

Thanks for your question, James. Both the etrailer #e98948 and Demco #DM9519336 base plates will have a very similar, low-profile look once they’re installed, so neither one really stands out more than the other. They’re both custom-fit for your…

view full answer...

Answer 7

Great question Mark, thanks for the details! Your WFCO WF-8955PEC-GE power center uses a removable converter section and the #WF76FR is the direct replacement main board assembly. It has WFCO's Auto Detect technology, which automatically switches…

view full answer...

Answer 8

Hey Tom! Since you already have your tow bar, the base plate #BX1139, safety cables #BX88197, and brake system #DM26VR cover the majority of what remains. You will also need tow bar wiring, and more than likely a high-low adapter to complete your…

view full answer...

Answer 9

Here is the Roadmaster Direct-Connect Base Plate Kit #1444-3 which Roadmaster said to use for your 2017 Jeep Wrangler Unlimited Rubicon. This comes with the arms for a Roadmaster Tow Bar #RM-676. If you are using a Blue Ox Tow Bar #BX4370 you will…

view full answer...

Answer 10

Hey Helbert! The etrailer Electric Trailer Jack #e64GV draws approximately 27 to 30 amps under load. A 100Ah LiTime lithium battery will have no problem powering this jack for normal operation, and will provide plenty of capacity for repeated raising…

view full answer...

Answer 11

Hey Stacey! To install the Victron Orion XS DC/DC RV Converter #VN93VR you will need appropriately sized wire and fuses. Victron recommends 16 mm² / 6 AWG (13.3 mm²) cable if the distance is less than 5 meters, and 4 AWG (21.2 mm²) if…

view full answer...

Best Replacement For Pollak 30 Amp Circuit Breaker

Product Page this Question was Asked From

Continue Researching