bing tracking image
Q & A Icon

Parts Needed for Installation of Victron Orion XS DC/DC RV Converter  

Updated 03/16/2026 | Published 03/13/2026

Question:

What else is recommended for installation of the Orion XS? Approximately how long does it take?

0

Expert Reply:

Hey Stacey! To install the Victron Orion XS DC/DC RV Converter # VN93VR you will need appropriately sized wire and fuses. Victron recommends 16 mm² / 6 AWG (13.3 mm²) cable if the distance is less than 5 meters, and 4 AWG (21.2 mm²) if it is 5-10 meters. They also recommend two 60-70A fuses, one on the input and one on the output side of the charger. See the attached photos.

The installation time will vary depending on the exact setup and if you're adding anything else like the SmartShunt # VN92ZR. Victron doesn’t list a specific install time, but for most setups it would typically take around 1-2 hours. I went ahead and attached the full installation instructions further down on this page for your reference.

What vehicle and battery setup are you running?

expert reply by:
0
Robin H
Cable Recommendations
Cable Recommendations
(click to enlarge)
Cable and Fuse Recommendations
Cable and Fuse Recommendations
(click to enlarge)

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>