Lid Wont Open on MaxxAir/MaxxFan Roof Vent Fan

Question

Question:

Hi. We have a 2020 Revel. The Maxxfan wont open on its own and the manual open knob is extremely tight to turn. Do we need a new operator? Please advise Thanks in advance.

asked by: Steven

0

Expert Reply:

If the lid won't open then that usually means either the motor or operator mechanism is bad. That said, if the manual knob is difficult to turn then that points to a bad operator mechanism instead of a motor and in which case you'd need the Replacement Operator Mechanism for MaxxAir MaxxFan Plus or MaxxFan Deluxe Roof Vents part # MA10-20281K-1AF. If you wanted to test the motor just as an extra precaution, you'd apply power directly to the motor as if it did not function you'd know it's bad and would need to be replaced with the Replacement Lift Motor for Maxx Fan Plus Roof Vent part # MA10-20270.

expert reply by: Conner L

0

Answer 1

If your roof vent lid won't open, even when using the manual lift knob, then the gears of the lift operator are most likely stripped out and the lift operator will need to be replaced. The Replacement Operator Mechanism #MA10-20281K-1AF is…

view full answer...

Answer 2

Hey Patricia, it shouldn't be that difficult to open the lid so I would look for something that's possibly interfering or a damaged component. Does the knob just turn or does it not want to move either? The operator mechanism part…

view full answer...

Answer 3

You reported that you cannot use the remote on your MaxxFan 4700K to put the vent cover up and down. Let's troubleshoot. Put some new batteries in your remote. Ensure that the display comes on. Verify if your vent cover now works. Verify if other…

view full answer...

Answer 4

If the knob is turning but you're getting no lift with your vent lid and you're able to simply lift it with a stick then the gear inside of your lift operator is most likely chewed up and in need of replacement. The correct replacement for a…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Lid Wont Open on MaxxAir/MaxxFan Roof Vent Fan

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching