Memory Mount Clamps for Inno Shadow Rooftop Cargo

Question

Question:

Hi does the RV inno Memory Mount Clamps for Inno Rooftop Cargo Boxes Item # INBRP9 compatible with: RV Inno Roof box br1200 and RV-INNO BR744?

asked by: Dino G

0

Expert Reply:

Inno rack BR1200 is the same as the Inno Shadow # INBRA1210BK which the Memory Mount Clamps for Inno Rooftop Cargo Boxes Item # INBRP9 can be used with. The other box you mentioned is not compatible nor do we have any hardware that would work with it.

expert reply by: Jameson C

0

Answer 1

The Inno Memory mount, part #INBRP9 will be compatible with your older LowDown Cruiser box.

view full answer...

Answer 2

There isn't really a maximum tightness on the Inno Memory Mount Clamps #INBRP9 that you referenced. As long as the clamps are secured around the crossbars they are going to provide a safe attachment. I did check with Inno and found that there is…

view full answer...

Answer 3

Hello Joe, Yes, I looked up the dimensions of the factory crossbars for the 2021 HR-V and the Inno Gear Case 720 Rooftop Cargo Box #IN94YV will attach nicely to them. I am always curious on what people plan on using their cargo box for: sports,…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Memory Mount Clamps for Inno Shadow Rooftop Cargo

Product Page this Question was Asked From

Continue Researching