How To Install The Curt T-Connector Wiring Harness In A 2002 Jeep Grand Cherokee

Published 10/21/2021

Products Featured in This Question

Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(117)

$43.49

Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(19)

$69.38

Question:

How do I locate the plug on my 2002 Jeep Grand Cherokee ?

asked by: LeAnne C

Expert Reply:

To install the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # C55369 you linked to in your 2002 Jeep Grand Cherokee without factory tow package you'll need to do the follow steps:

1. Remove the rear threshold seen in figure B/C

2. Remove the screws on the driver side trim panel and pull back the panel to gain access to the green vehicle harness (D,E,F).

3. Insert the green custom wiring connector housing into the green vehicle harness housing. Make sure the connectors are fully inserted with locking tabs in place by pushing the red lock tab to the side (G).

4. Locate a flat spot inside the vehicle, near the taillight. Adhere the black converter box using the provided double-sided tape (H). Insert the 10-amp fuse provided into the red inline fuse holder.

5. When in use, route the 4-flat to the center of the vehicle. When not in use, roll up and store in a convenient, out of the way location. Secure any loose wires with the provided cable ties.

I don't have an installation video of this specific wiring harness but I have attached an installation video for the Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # 42535, which is a similar wiring harness and will allow you to see all of these steps being done.