Correct TorkLift Camper Tie-Downs for a 2020 Chevy Silverado 1500 with Dual Exhaust

Question

Question:

will it fit on my 2020 silvaredo trailboss dual exhuast crew cab?

asked by: Hamad

0

Expert Reply:

The correct TorkLift Custom Frame-Mounted Camper Tie-Downs for a 2020 Chevrolet Silverado 1500 with Dual Exhaust is part # TLC2224 for the front and part # TL54FR for the rear. If you don't already have turnbuckles, I recommend the TorkLift Locking FastGun Turnbuckles for Frame-Mounted Tie-Downs part # TLS9529-2-LK.

expert reply by: Conner L

0

Answer 1

Hey Pat! You will get both front and rear tie downs when you purchase the TorkLift Tie Downs item #TL79VV. The item #TL79VV gives you the following parts: TorkLift Camper Tie-Downs - Front - item #TLC2224 TorkLift Camper Tie-Downs - Rear - item…

view full answer...

Answer 2

Yes I confirmed with TorkLift that those were the correct fitting tie-downs for your 2020 GMC Sierra 1500 with 6.5' bed without board underneath bed and factory installed hitch with dual exhausts. So you'll need the TorkLift Custom…

view full answer...

Answer 3

Hello Sheri, thanks for reaching out. The TorkLift Tie Downs #TL79VV will fit the 2025 GMC Sierra 1500, as long as your factory running boards are cab length only. If they extend beyond the cab to the wheel, they will obstruct the tie downs, but as…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

Hey Matt, Furrion typically has 4 wires running to their thermostats and the Chill Cube Thermostat #LC74DX is no exception. The harness you see with the thermostat would plug into the Chill Cube's controller and has 4 wires to extra wire to to…

view full answer...

Correct TorkLift Camper Tie-Downs for a 2020 Chevy Silverado 1500 with Dual Exhaust

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching