What Are the DOT Requirements for License Plate Lights
Updated 10/14/2020 | Published 10/13/2020
Products Featured in This Question
Question:
I rebuilt the whole back end of my travel-trailer and replaced the original taillights with Optronics STL178RB and therefore need a separate license plate light. ... I copied the following from your product description: “DOT approved when properly mounted. Requires single light mounted at trailer center, or 2 lights mounted on each side.” — I was wondering if this is indeed accurate and for some reason I must install both the license plate and light at the trailer center, or should it instead read “at license plate center”? — I’ve seen lots of trailers with license plates on the left side like my trailer originally was, and would like to install underneath the new STL178RB in the picture... So I wanted to be sure about this specific product because I’d rather not install it on the bumper which would otherwise be my only other option, because of the double-doors on the back. — Also, if you would please give a brief overview of what you mean by “DOT approved when properly mounted”... Thank you very much.
asked by: Michael M
Helpful Expert Reply:
You'll only need a license plate light like the # OPT77FR directly over the license plate, on whatever side of the trailer that you're mounting the plate. What the 2 on each side is referring to is that you could use 2 lights on each side of the license plate if you wanted, or 1 directly over the center of the plate, but I can understand why the wording here is confusing.
You can easily mount this under the # STL178RB you've already installed and make the trailer DOT compliant. I've linked one of our helpful articles that we did outlining the DOT requirements of trailer lights that you can refer to.
Product Page this Question was Asked From
Mini LED Trailer License Plate Light - 2 Diodes - Clear Lens - 12V/24V
- Trailer Lights
- License Plate Lights
- License Plate
- Rectangle
- Non-Submersible Lights
- LED Light
- 2-3/4L x 1-3/8W Inch
- White
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: MaxxFan Plus Roof Vent w/ 12V Fan and Thermostat - Manual Lift - 4 Speed - White
- Shop: Rich Solar Mega 250 Pro Solar Panel - 24V - 250 Watts - Black
- Q&A: Rain Sensor Location on MaxxFan Plus Roof Vent # MA00-04500K
- Video: A Closer Look at the MaxxFan Plus Roof Vent w/ 12V Fan and Thermostat
- Video: Review of Rich Solar RV Solar Panels - RS65FR
- Q&A: How High Does Dometic FanTastic Roof Vent Sit Above Roof With Dome Removed
- Shop: Replacement MaxxFan Plus 4-Speed Roof Vent with White Lid
- Shop: Vehicle Tow Bar Wiring
- Shop: Vent - White Top w/12V Fan and Crank Out w/Screen
- Shop: Mini LED Trailer License Plate Light - 2 Diodes - Clear Lens - 12V/24V
- Video: Feature Breakdown: Replacement MaxxFan Plus 4-Speed Roof Vent with White Lid
- Video: Checking Out the MaxxFan Plus Roof Vent w/ 12V Fan, Thermostat, and Remote
- Video: Feature Review MaxxFan Deluxe Roof Vent w/ 12V Fan
- Shop: Velit 2000U Under-Bench AC for Vans and Small RVs w/ Remote - 8,500 Btu - Ducted - 48V DC - Black
- Shop: Ventline Ventadome Trailer Roof Vent w/ 12V Fan - Manual Lift - 14-1/4" x 14-1/4" - White
- Article: Trailer Lighting Requirements
- Search Results: 7 pin
- Video: Deka Jacketed 4-Wire Spec Review
- Search Results: terminal block
- Q&A: Will The Curt Towed Vehicle Wiring Harness # 58964 Light Up The License Plate
- Search Results: custom fit vehicle wiring
- Search Results: trailer wiring
- Q&A: Installing Vehicle Side Trailer Connector to Trailer Deep Cycle Battery to Power 12V Interior Lights
- Search Results: curt 58964
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Which is Better Roadmaster or Blue Ox Tow Bar
- Q&A: Difference Between Trailer Taillight Kits that are for Over 80 inches in Width and Under 80 inches
- Q&A: Lighting Requirements for Trailer that is over 80 inches in Width
- Search Results: trailer jack
on Trailer Lights
