Can Camco Cover and Base for RV Propane Tanks both Install at Same Time

Question

Question:

Would this Camco Base fit underneath this Camco Cover? I have a flat platform that I wanted to put the base on then cover with the Camco as a clean unit. Cover: Camco RV Polyethylene Propane Tank Cover for 1 20-lb Steel Tank - Black Item # CAM40565

asked by: Keith

0

Expert Reply:

The Camco Cover part # CAM40565 and the base part # CAM57236 both can't install at the same time. You'd have to decide which of these two you'd want to use. Basically there isn't room in the cover for the base to also fit.

expert reply by: Jameson C

0

Answer 1

We have the exact replacement Blue Ox 400 - 600 lb round spring bars you need, at the following part number: - Replacement Spring Bars for Blue Ox 2-Point Weight Distribution System #BLU94XR

view full answer...

Answer 2

Typically what people do to mount the propane tank covers like the part #CAM40542 is to use a bungee cord like #EM06755 to secure it below the tanks. The cover has two tabs on the bottom of it that allow for the hooks of the strap to be attached to…

view full answer...

Answer 3

Welcome back Jeff! You can definitely change the bars in your Blue Ox 2-Point weight distribution system. This uses the same head across all 3 weights. so that will be perfectly fine to do. I have all three spring bars listed below as well:…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 9

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Answer 10

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 11

Hey Kent! Your Alliance Avenue already has some great suspension components with the MORryde CRE3000 equalizers, wet bolt kit, and Rota-Flex pin box. I wouldn't replace any of those unless you're experiencing a specific problem. The next…

view full answer...

Answer 12

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Can Camco Cover and Base for RV Propane Tanks both Install at Same Time

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching