Are Submersible Trailer Lights Guaranteed Against Leakage

Question

Question:

Are the submersible trailer lights guaranteed against leakage?

asked by: Karen

0

Expert Reply:

I have an explanation for you. Light kits like the LED Combination Tail Light Kit for Trailers under 80" Wide - Submersible part # TLL56RK and other submersible trailer light are actually a little confusing. They are not completely sealed, if fact it is just the opposite there are drain holes on the light that will allow for the water to drain out of the lights after they have been submerged. On incandescent type submersibles there is a thin plastic shield around just the bulb to keep cold water from hitting a hot bulb causing damage to it.

So in my mind it is a little backwards. I originally thought years and years ago they were impervious to water where really they are designed to release the water after it gets in.

expert reply by: Randy B

0

Answer 1

I really like the LED Combination Tail Light Kit for Trailers part #TLL56RK. It offers LED lights which you won't have to be replacing bulbs in and with the submersible design you won't have to worry about water. It has the 4-way connector to…

view full answer...

Answer 2

We carry all sorts of replacement trailer lights including taillights that you can see on the linked page. Since trailer makers do not maintain detailed specs on the lights they install during production you can match up the size, shape and functions…

view full answer...

Answer 3

It sounds like you're looking for a set of submersible tail lights, and which ones you'll want to use depends on the other type of lights you currently have on your trailer-i.e. LED or incandescent. If you've got incandescent lights…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 11

Hello John, thanks for reaching out. Yes, the mounting holes on the TecNiq Contoured Seven Function Box Style Tail Light #TN42XR (driver side) and #TN62XR (passenger side) are exactly the same as the Wesbar 271595 tail light. They are 2" apart…

view full answer...

Answer 12

Hey Eli! The first thing you want to do is make sure you have brake flanges on those axles. You also need to take a look at the axle tags and find the axle capacity. More than likely they're 3,500 lb axles so I'll answer based on that. If you…

view full answer...

Are Submersible Trailer Lights Guaranteed Against Leakage

Product Page this Question was Asked From

Continue Researching