Will a 2016 Ford Fusion SE Tow a 1,100 Lb Trailer

Updated 04/11/2019 | Published 04/10/2019

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"

(487)

$173.29

T-One Vehicle Wiring Harness

(77)

$65.54

1-7/8" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Stainless Steel - 2,000 lbs

(343)

$34.49

2" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Stainless Steel - 3,500 lbs

(343)

$36.80

Curt Class II Drawbar - 2-5/8" Rise, 3-1/4" Drop - 9-3/8" Long - 3,500 lbs

(2282)

$41.29

Derale Series 8000 Plate-Fin Transmission Cooler Kit w/Barb Inlets - Class II - Efficient

(874)

$88.31

Question:

Thanks for breaking down towing capacity, maximum towing load, tongue weight and everything else. I apologize for asking a dumb question but what would happen if my 2016 Ford Fusion SE is a 1.6L with max capacity of 1,000 pounds and I have 1,100 pounds on it? Is it that it will just be slow to speed up or is the tow hitch going to rip out or something?

asked by: Nick

Expert Reply:

I cannot recommend that you tow a 1,100 lb trailer with your 2016 Ford Fusion SE that has a maximum towing capacity of 1,000 lbs for liability reasons but in all honesty, you would most likely be just fine. Personally, I wouldn't really be concerned with towing over capacity by only 100 lbs. I would just avoid hilly areas if at all possible.

In order to tow a trailer with your Fusion you will need a trailer hitch, trailer wiring harness, and ball mount/hitch ball. Also, if you will be towing frequently then you might consider an additional/upgraded transmission cooler as well but this is not a requirement like the above items are.

For a trailer hitch, I recommend the Curt Trailer Hitch Receiver part # C12091 because it has one of the highest weight capacities available and the more margin you have the better off you will be. This hitch is also a custom fit so no drilling is required and it is super easy to install. I have attached both an install video and photo for you as well.

For a trailer wiring harness, I recommend the T-One Vehicle Wiring Harness part # 118574 because we find this brand to be the most reliable with their wiring products. This harness is also a custom fit so no splicing is required. I have attached an install video for you as well.

For a ball mount, I recommend the Curt Class II Drawbar part # C45016 with either part # A-80 or part # A-82.

If you choose to install a transmission cooler as well then I recommend the Derale Series 8000 Plate-Fin Transmission Cooler Kit part # D13501 which has everything that you need.