2 Inch Trailer Hitch Receiver for 2016 Ford Fusion for Electric Bikes

Question

Question:

We saw a video of the installation on a 2016 fusion. It mentioned you'd need stability straps if using the hitch for a bike rack. I don't know what that is but wondering if that is true. Also, wed want a 2inch receiver that could hold a rack plus two bikes @ 50lb each. Secondly, where in Utah ccould we get this installed. thanks so much.

asked by: Jane

0

Expert Reply:

There is one trailer hitch with a 2 inch receiver that fits your 2016 Ford Fusion, which is from EcoHitch:

- EcoHitch Hidden Trailer Hitch Receiver # 306-X7239

This is the only hitch with that size receiver that fits your vehicle, but it does not require Stability Straps # 18050, as those are only needed for the Curt Trailer Hitch Receiver # C12091 that also fits your car (but has a smaller 1-1/4 inch receiver).

In regards to the bike rack, since the hitch pin hole is recessed a good amount under your Ford's bumper, and sits pretty low to the ground, there is one bike rack I recommend above the rest that has the needed clearances and is able to handle a couple of 50 lb electric bikes. The rack is the Saris Freedom, and the right one will depend on if your bikes have standard tires that are up to 3 inches wide, or fat tires that are up to 5 inches wide.

- Tires up to 3 Inches Wide: Saris Freedom 2-Bike Rack # SA4412B

- Tires up to 5 Inches Wide: Saris Freedom 2-Bike Rack for Fat Bikes # SA4412B-FB

This rack is perfect for you because it has a 60 lb per-bike capacity, measures 12 inches from its hitch pin hole to the closest part of the rack, and has an 9 inch rise in the shank. That means it will easily clear your bumper, and give you the needed ground clearance to keep the rack from scraping the ground if you go over a large bump, for example.

In regards to installation, we do not have any affiliations with or know of any specific installers, but any local or even mobile mechanic will have no problem doing the install. Just make a few quick calls to local shops to see who has experience and you'll be able to find someone in no time.

expert reply by: Kyle S

0

Answer 1

Long story short you would need a trailer to transport a heavy duty power scooter with a 2015 Ford Fusion. The highest rated hitch we offer for your vehicle is the Curt part #C12091 that has a 350 lb tongue weight rating which doesn't sound like…

view full answer...

Answer 2

Thank you for the photo of your Specialized Vado bike's front fork area which shows the fender and fork bridge. A wheel-mount rack such as the RockyMounts MonoRail Solo 1 Bike Platform Rack #RKY10007 will work for your Vado if you remove the…

view full answer...

Answer 3

Just looking at your Tern HSD bike with fenders, I'm going to say no the Saris MHS Bike Rack for 1 Bike #SAR23MR is not going to work. I did some research and it looks like a lot of Tern owner's went with the Hollywood Racks Sport Rider SE…

view full answer...

Answer 4

I have a solution for you, but because of the weight of your e-bike, you're going to be extremely limited when it comes to options for carrying it on the roof of your vehicle. The best solution to carry your bike on your roof rack is the Inno…

view full answer...

Answer 5

Yes, it does Jay! The EcoHitch item #306-X7239 has been confirmed to fit all models, except for the Sport, of the 2020 Ford Fusion plug-in hybrid. This is a class III hitch, with a 2" receiver, that is custom fit, and includes all installation…

view full answer...

Answer 6

There is not always a speaker behind the rear bumper on the Ford Fusion, so you will need to check under the bumper to see if your particular 2013 Ford Fusion has the speaker or not. If you do you will need the #18136 to make a bracket to move it out…

view full answer...

Answer 7

The Thule Epos #TH99XE will work with a car, truck, SUV, or van. Unfortunately, it will not work with a motorhome or trailer. For a 2-bike rack that can handle heavy bikes and is motorhome compatible I recommend the Hollywood Racks RV Rider Bike Rack…

view full answer...

Answer 8

If you were to install the EcoHitch #306-X7239 on your 2017 Ford Fusion then you would have to permanently remove the plastic underbody panel as you can see from the attached photo which is directly from the instructions. I have also attached a photo…

view full answer...

Answer 9

For a cargo carrier that you'll be using on the back of a trailer you will need a fixed carrier as opposed to a folding one to have the best stability. There are a couple options for a fixed cargo carrier with a ramp for you. I recommend the…

view full answer...

Answer 10

Yes, there is a set of crossbars that will fit the factory side rails of your 2023 VW Arteon. This mounts directly to the side of your door frame and has more than enough capacity for a bike rack. You will want the roof rack by Thule and it includes…

view full answer...