Install Instructions for Curt Trailer Hitch # C11555

Question

Question:

Quick follow-up - in the meantime with fixing the 502 - Bad Gateway error, can you attach the PDF instruction manual with your email response? Thanks,

asked by: Tom M

0

Expert Reply:

I attached a picture that shows the install instructions for the Curt hitch part # C11555 that you referenced for you to check out.

expert reply by: Jameson C

0

click to enlarge

Answer 1

I went ahead and checked out the Kuat Transfer V2 #KU24FR on Kuat's website and they say that this rack will accommodate an 18"-29" wheel as well. This rack also can hold up to 3-bikes weighing 40-lbs each, and will work with bikes that…

view full answer...

Answer 2

I'd be happy to help! All of the hitches for your 2011 Honda CR-V weigh relatively the same when it comes to the different classes, and while the Class I hitches definitely weight lighter I recommend using a Class III hitch since they have a…

view full answer...

Answer 3

The Hidden Hitch by Draw-Tite Trailer Hitch Receiver #DT46GR is the most concealed option for your 2023 Chrysler Pacifica. This allows you to remove the 2" receiver when not needed so you will not see any portion of the receiver below your rear…

view full answer...

Answer 4

Thanks for the picture! I just spoke with my rep at Thule his solution was to replace it because the spring and the locking mechanism has gone out. They do not offer just the locking pin portion because it is riveted onto the frame. Instead you will…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

The Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2", part #75547, will still be my recommendation. It has a maximum tongue weight of 675 lbs and a maximum gross tongue weight of 4,500 lbs, which is greater than the other…

view full answer...

Answer 7

The 3 x 3 inch cutout in the under body panel is to accommodate the mounting flange of the Curt #C11555 hitch on the passenger side. This is shown in the linked install video beginning at the 5:35 minute mark.

view full answer...

Install Instructions for Curt Trailer Hitch # C11555

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching