Recommendations for Towing a 2017 Fiat 500 Behind a Motorhome

Question

Question:

asked by: Darryl

0

Expert Reply:

If you have the automatic transmission, then your 2017 Fiat 500 FWD must be towed using a tow dolly like # RM-2050-1. This is due to the transmission design style to prevent damage. If you have the manual 5 speed, you can tow it as it with a speed restriction of 65 mph.

If you have the manual 5 speed transmission, I recommend the following:
*Roadmaster EZ2 Base Plate Kit - Removable Arms # 522013-1A
*Roadmaster Falcon 2 Tow Bar - Motorhome Mount - 2" Hitch - 6,000 lbs # RM-520
*Safety Cables # RM-643
*Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit # RM-15267
*SMI Stay-IN-Play DUO Supplemental Braking System - Proportional # SM99251
*Roadmaster Stop Light Switch Kit - Fiat # RM-751455
*Finally, a high-low adapter. I've attached an article to assist and linked the page to your options.

Let me know if you have any questions.

expert reply by: Jason S

0

Ted S.

3/10/2020

can a 2012 fiat 500c automatic be flat towed

Chris R.

3/11/2020

Your 2012 Fiat 500c with the automatic transmission can only be towed behind an RV using a dolly with its rear wheels on the ground. It cannot be flat towed with all 4 wheels on the ground.

Answer 1

Hi Michael! Do you already have a 7-way on your Transit? If you don't have wiring, you need to start by adding a 4-way with #C56327 (single rear wheel) or #C42MJ (dually). Once you have your 4-way installed you can upgrade it to a 7-way using the…

view full answer...

Answer 2

Actually, the P3 now has the upgraded axis accelerometer like the P2. The Tekonsha P3 Trailer Brake Controller #90195, will work with both electric over hydraulic brakes on the trailer as well as electric brakes. It has a menu option on the display…

view full answer...

Answer 3

You're right, the mounting bracket is unique (in a good way) for the Curt TriFlex NEXT Trailer Brake Controller #C24VV. The bracket is smaller and all you do is put the included adhesive tape on the bracket and stick it wherever you like under…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 6

We can get you everything you need for towing with your 2017 Toyota Sienna XLE. By plastic shield, I believe you are referring to the appearance panel underneath the Sienna, and that will have to trimmed a bit in each of the hitches available for the…

view full answer...

Answer 7

Hey Brandon, I would strongly recommend sticking with the Tekonsha RF brake controller part #TK94FR. We know this works really well and it sounds like it worked well for you too. The Curt Echo is not reliable enough for me to really ever recommend it…

view full answer...

Answer 8

Hey Bob. There's two possible locations for the brake controller port on your 2026 Ford F-150. The most likely one is on your dash behind the coin holder above the 4WD knob. It'll be connected to the back of the coin tray which is only…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

It sounds like you may already have a 4 way connector on your vehicle, which is half of the battle. In order to operate the Curt Echo Mobile Wireless Brake Controller #C51180 you will need an almost fully functional 7 way connector; using something…

view full answer...

Answer 11

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 12

Hey Ken! The correct wiring harness depends on whether or not you have the brake controller port/plug. Some models did not include the plug so you will have to check your 2025 Ranger and see. There should be four wires coming out of a large wire…

view full answer...

Recommendations for Towing a 2017 Fiat 500 Behind a Motorhome

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching