Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
When your trailer is over 80" wide, visibility and compliance matter. This Optronics identification light bar measures 14-1/4" long x 1-3/16" tall x 1-5/16" deep and features three red 3-LED lights—nine diodes total—mounted on a corrosion-resistant stainless steel base. The lights are DOT compliant and P2 or P3 rated for clear, bright output across a 90-degree beam spread. With only a 0.153-amp draw at 12.8V, it offers strong illumination without overloading your running light circuit.
If your trailer ever backs into the water, this light bar is ready for it. Each red LED module is sonically sealed with its polycarbonate lens to form a single waterproof unit. The sealed design keeps moisture out so the diodes and circuit board stay protected from corrosion or shorts—even after repeated submersion. It’s a dependable choice for any trailer that sees rain, spray, or launch ramps.
Long days on the road or at the dock can be hard on lighting hardware. The stainless steel base of this bar resists rust and corrosion far better than coated steel or plastic mounts. It stays secure and good-looking season after season while keeping the three light modules solidly supported for steady performance.
Wiring doesn’t need to be complicated. This light bar uses a single power wire with a molded 0.180" male bullet connector that ties into your running light circuit. The ground connection is made through the mounting hardware, making installation straightforward. You’ll just need two 5/8" x 1/4" stainless steel screws (not included) to mount it securely with an 8-1/2" center-to-center hole spacing.
Forget about burned-out bulbs or fragile filaments. These LEDs last up to 50 times longer than incandescent lights and deliver brighter output with less power draw. There are no bulbs to replace—just steady, maintenance-free lighting backed by a lifetime LED warranty so you can focus on towing instead of troubleshooting lights.
Customer Satisfaction Score:
98% were satisfied with this product
2% of customers were not satisfied
Ratings & Reviews
I have ordered several times from etrailer and both times have been very satisfied with their service and the products. I have several different trailers, stock trailer, flatbed utility trailer, small bumper pull camper and a 5th wheel camper and for every one of these trailers, if I need parts I first look to etrailer.
This was the exact replacement for my 2005 boat trailer. Even the dealer I bought the boat from was going to have to order it and send it to me. Forget that!! Etrailer not only had it but was also cheaper and got it to me in faster time. It arrived and was exactly what the etrailer specs. said even down to fitting the screw holes of the original one. The original one had two wires, + and - while this one only came with the +(positive). No problem, it acquired its - (ground) through the mounting screws but to make sure, I went ahead and used the trailer - (ground) wire with a crimp fork connector over to the mounting screw for good measure. Thanks again etrailer.
Easy install on a boat trailer. Holes lined up with old light bar. All that needed to be done was snip the + wire, strip it and crimp it to the trailer wire with a waterproof shrink butt connector. Just for giggles, a piece of waterproof shrink wrap was placed over the butt connector. Overkill to be sure but it certainly won't leak.
Ordered a new LED trailer light. Exact match everything lined up perfectly. Also gave the opportunity to tidy up some of my trailer wiring. Great when it all goes according to plan
Dealing with etrailer was great. Found what I needed quickly, delivered quickly, the one question I had addressed quickly. It was such a relief not having to run all over town trying to find boat trailer lights, there is very minimal selection in the town where I live. I actually ordered 4 lights, a driver-side multi function, center identification pictured above, and two amber clearance lights. Everything about the order was perfect.
Will not hesitate to do business with etrailer again. Thanks a mil! Ray C, Santa Maria California
The LED bar lights are superior to the original incandescent lighting. I also switched the taillight assemblies to LEDs. The trailer is more easily seen now. Etrailer had all the products I needed and was always helpful. I will go to them first for all trailer products.
I switched my old lights with led lights and I believe it is the smartest thing I have done for my trailer yet. The lights are at least 10X brighter which makes you more visible which in turn makes you safer.
I would recommend this to everyone and etrailer has the best prices !!
I give this product only 3 stars because I have not installed it on my trailer, and not sure if I will at this point. But it looks really nice and in etrailer's video it looks nice when lit up. I decided to go a different route with my ID bar after I received this, but I will keep it for another trailer lighting upgrade! I still recommend this ID bar!
This light bar was easy to install. It fit right into the spot where the factory light was on my boat trailer. The LEDs are much brighter than the original lights and look great on the trailer.
replaced trailer wireing with thicker wire, replaced 4 side marker lights led, replaced both tail lights led, all worked and look good. I just hope these led lights last a long time. the lights I took off all worked, but were not as bright as I wanted, they were the original lights that were on my pontoon boat trailer.
Haven't installed yet but I did test it on a 12 Volt battery. Very bright, much better than the factory clearance light on my 94 Bayliner trailer. Prewired with ample wire to complete the install. Small glitch in packing and the light got damaged enroute to me. Brian in Cust Service quickly resolved the issue and kept in communication with me until resolved. One more reason etrailer.com is one of the top internet suppliers on my go-to list. Thanks.
I purchased a trailer light bar (LED Submersible 9 diode Red Lens MCL97RPG) to replace the original one on my boat trailer that had stopped working (14 years old). Purchase price was 60% of what I was quoted at local shop for a like bar. Order was delivered in a couple of days which was faster than expected and I had no issues replacing the old with new. Screw holes aligned perfectly and the only extra I did was purchase additional stainless steel screws and washers to attach bar to trailer. Thanks etrailer.com for a quality product that work right the first time.
Works great and looks even better.
Super product - - like both the Stainless Steel construction and the VERY bright LED lights. We used it to replace a very poor plastic version on our 1986 Supra Inboard Ski Boat trailer. This install was a part of a complete re-wiring and re-lighting project. We are very pleased with the END RESULTS. I highly recommend this product. Keep up the GREAT-WORK - - etrailer.com TEAM. (Don H, Akron, OH)
I have installed this light bar on my boat trailer. Very good quality product. The shipping was fast. Thanks etrailer!
Rewiring my auto hauler. Found all the necessary lighting on the "etrailer" website. I have ordered from them before and again was impressed with product quality as well as the fact that they keep in touch with letting you know status of your order. In my case some lights I ordered were not in stock but they let me know as well as let me know when roughly they expected to get them. I like this kind of service and relationship. No surprises or empty promises. I am a very happy customer. J.P. Coos Bay, Oeregon.
James P.
3/12/2017
All products purchased from E-trailer have and are being used. The lights in particular are good quality, fit and finish and have exceeded my expectations.
Perfect replacement. Fast, dependable shipping. Thanks.
I bought the whole set of LED lights - side and front side marker, tail lights, rear marker bar. It was quite a project getting them all in as they were of course slightly different than the 13-year old originals. But it turned out well and I was very pleased with the quality of all the components.
Jim S.
10/17/2017
All trailer parts are doing well. Saltwater even.
Purchased as part of a complete rewiring of my boat trailer. I wanted waterproof led lights all around. I was pleased that the light assembly mounted in the existing holes in my trailer frame so installation was easy.
Best news, one year later the lights still work and the stainless steel still looks new, the trailer is kept outside and has been underwater (fresh water) many times throughout the boating season. I am happy with this item.
Td
9/16/2018
Lights are all still working great, zero problems. Trailer is stored outside and the boat is used in fresh water.
All the products I ordered arrived quickly and were exactly as described. The LED trailer lights and light bar are brighter than the regular light bulbs on my trailer. The tongue jack works very well, and replaces the original 30 year old tongue jack which was worn out , and on it's last leg. The wiring clips perform as expected, as did the metal license plate bracket. The metal bracket replaced the broken plastic one on the trailer. Very happy with eTrailer prices, and shipping. Thanks!
Allena
10/25/2016
The Optronics Trailer Lights are working perfectly. They add that difference when Im towing my 9 foot wide boat.Thanks for the follow up,
Nice, bright and easy to install. A much needed upgrade from the incandescent bulbs. Makes my boat trailer look great!
This is the second great experience I’ve had with your company. Even though the item wasn’t in stock you kept me informed and got it very quickly. I highly recommend etrailer.
this light bar is exactly what I needed to finish off my home built trailer. Though it hasn't been attached to the rear bumper as yet. You have to agree its going to look great. Thanks etrailer.
4 stars because I haven't been able to install yet. The light bar came well packaged a day early. It appears to be an exact replacement for the one on my boat trailer. The old one had shorted out and this one, being LEDs, are sealed and submersible. Not my first purchase from Etrailer, and probably not my last. Great website - easy to use - great devilery and follow-up! Who does that anymore?
Been replacing taillights and clearance lights on my 1992 boat trailer. Opted for sealed LEDs to replace all the old incandescent ones that I had to work on every year to keep em going. These are brighter, sealed for water resistance and very easy to install, plus they require less power and work so much better. I'm super pleased with all the products I've gotten from e trailer, quality stuff, fast secure shipping. Picture shows Optronic tail lights I added as well. Great company, that offers great products!
Do you have a question about this Trailer Light?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Albert A.
5/10/2021
Great!