Troubleshooting Light Bar # MCL97RPG Not Operating Properly
Updated 08/27/2018 | Published 08/25/2018 >
Products Featured in This Question
Question:
I recently purchased the product above and installed it on my trailer. I connected the brown wire from the light unit to the brown wire on my trailer wiring. I used mounting screws to mount it to the trailer because I know that the product grounds via the mounting screws. The light doesnt illuminate. Can you suggest somethings to look for that I may have done wrong?
asked by: Todd B
Expert Reply:
The first thing to do would be to check to see if the problem is the Light Bar # MCL97RPG or the wiring on your trailer. With the light grounded try touching the brown wire to a 12V power source to see if it illuminates. If it doesn't then the light bar is bad but if it does that means the light circuit for the brown wire on your trailer isn't working correctly. You can try tracing down the damaged wire section with a tester like part # PTW2993. Fix any damaged sections and that should fix your problem!
It could also be that the ground connection isn't the greatest. You can also try sanding off the mounting location to get a better ground connection if need be.
Product Page this Question was Asked From
Identification Light Bar for Trailers over 80" Wide - Submersible - 9 LEDs - Silver Base - Red
- Trailer Lights
- Clearance Lights
- Marker
- Light Bar
- Surface Mount
- Submersible Lights
- LED Light
- 14L x 1W Inch
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Availability of 2-5/16" Ball For Weigh Safe Aero Hitch
- Q&A: Will Scale of Weight Safe Ball Mount with Scale Break When Hitting Bumps
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Trailer Lighting Requirements
- Q&A: Wiring New 4-Way Connector on Trailer with 5 Wires
- Q&A: Replacement Lens for SAEAP2 16 DOT Clearance Light
- Q&A: How To Determine Blue Ox Spring Bar Weight Capacity
- Q&A: Oil Seal With 1.68 Outer Diameter And 2.56 Hub Inside Diameter
- Q&A: Identification Light Bar for Trailers over 80" Wide that Grounds Through the Mounting Hardware
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Trailer Tire Sizing


