Hardware to Install Optronics Light Bar
Published 11/11/2019 >
Question:
what hardware should I use to install this?
asked by: Eddie
0
Expert Reply:
Optronics tells us to use two 5/8 x 1/4 inch stainless steel screws to install the # MCL97RPG light bar.
expert reply by:
Charles S
0
Product Page this Question was Asked From
Identification Light Bar for Trailers over 80" Wide - Submersible - 9 LEDs - Silver Base - Red
- Trailer Lights
- Clearance Lights
- Marker
- Light Bar
- Surface Mount
- Submersible Lights
- LED Light
- 14L x 1W Inch
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Availability of 2-5/16" Ball For Weigh Safe Aero Hitch
- Q&A: Will Scale of Weight Safe Ball Mount with Scale Break When Hitting Bumps
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Trailer Lighting Requirements
- Q&A: Wiring New 4-Way Connector on Trailer with 5 Wires
- Q&A: Replacement Lens for SAEAP2 16 DOT Clearance Light
- Q&A: How To Determine Blue Ox Spring Bar Weight Capacity
- Q&A: Oil Seal With 1.68 Outer Diameter And 2.56 Hub Inside Diameter
- Q&A: Identification Light Bar for Trailers over 80" Wide that Grounds Through the Mounting Hardware
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Trailer Tire Sizing


