2021 Coachmen Apex Travel Trailer Lippert High-Speed Power Stabilizer Jack: Complete Installation Video

The Lippert Components Power Stabilizer Trailer Jack #LC298707 that you referenced will work as a replacement for your 198641 stabilizer jack. If you use the Linc Analog Remote #LC292614 for your RV then this is compatible with that as well. The part…

I was able to cross-reference your part number and the C-800 Replacement Klauber Motor for Standard Lippert Components Electric Stabilizer Jacks #LC138445 is the updated motor for your trailer jack. It will be a direct replacement.

The distance between the mounting holes of the etrailer Bolt-On Swivel Mounting Plate #e52JR that you referenced is 3-1/2 inches.

Scissor jacks don't actually support that much of the trailer's weight, more just the downward force on the trailer from moving around inside of it so the Scissor Stabilizer Jacks w/ Handle #TJSCHD-24-4 you were looking at would be more than…

I have included a picture showing how the motor and switch wire up on the Lippert stabilizer jack #LC298707.

The direct replacement for your Lippert Model 113407 stabilizer jack is part #LC369774. I confirmed this with my contact at Lippert. It requires an easy bolt-on installation.

The Electric Stabilizer Jack Support Arm #LC1134122 and Foot Assembly #LC157584 are the only replaceable parts for the legs on your Lippert PSX1 Stabilizer Assembly #LC298707. If you bent the leg itself you will need to replace the entire assembly.

It looks like the trailer manufacturer created their own lift brackets to use with the older Lippert High-Speed Power Stabilizer Jack. I'm sure you could reuse these by welding the new Lippert High-Speed Power Stabilizer Jack part #LC298707 to…

The Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 4-Point Set #LC358590 has 4 35-amp fuses located on the controller. Attched is a complete wiring diagram for you to check out.

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

For your Lippert Components Power Stabilizer Trailer Jack #LC298707 the wiring is pretty simple. There are two wires that come out of the motor and they are both used as power or ground depending on the direction you want to turn the motor. To…

Yes, you can use a drill to make raising and lowering the scissor jack set part #JSC-24 a bit quicker. You'll just need the drill adapter part #UF48-979005 too and you'd be set. This basically is a socket attached to a power drill shank. The…