Wiring Diagram and Fuse Location for the Lippert Ground Control 3.0 4-Point Leveling System  

There may be a bunch of different reason why your Lippert Level-Up system has suddenly stopped working. The most common reasons are due to a dead battery, extending your jacks too far, or a blown fuse. The first thing you should check for is the…

The blank screen on your LCI Ground Control 3.0 could be either a power issue or a control module issue. I recommend first remove the panel and unplug it from the back leaving it unplugged for at least 15 minutes so that it loses all of the residual…

Yes, the Curt Custom Base Plate Kit #C36JR is confirmed to fit your 2020 Ford Expedition 4wd. It will also allow for you to use a Blue Ox Tow Bar #BX7420. Do ensure you install a Charge Line Kit #RM-156-25 as the battery will while being flat towed…

Your best option is to replace the unit with the 6 point kit part #LC675817. We've actually asked Lippert about upgrading a 4 point to a 6 point in the past and they have told us it's not possible since basically everything is different aside…

I have included a picture showing how the motor and switch wire up on the Lippert stabilizer jack #LC298707.

The correct replacement control module for the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System - 4-Point part #LC358590 is the Replacement Control Module for Lippert Ground Control 3.0 Electric Leveling System part #LC304136.

Please refer to the linked photo for guidance in how to wire the landing gear motor switch on your 2007 Keystone Montana 5th wheel to both the motor and trailer battery.

The correct replacement part is the Replacement Motor for Lippert Power Gear Electric Leveling Jack System - Right, part #LC89CJ, if your are replacing the right motor. I have included a product description link and video demo link below. .

There are a couple potential reasons why the back Lippert Power Jack #LC298707 on your trailer won't extend or retract even with the motor running. It's possible that it may have been over-extended or something internally has been stripped or…

Installation of the #LC305339 will only require plugging the leg wiring harness into the wiring harness attached to your controller. I have attached a wiring diagram for the 4-point and 6-point system below.

It sounds like you might have an Ultra-Fab landing gear set. I have included a diagram showing how the system gets wired. On it the white wire is the power wire and the green wire is the ground.

The Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 6-Point Set #LC675817 or the 4-Point Set #LC358590 can be added to your 2012 Keystone Alpine 5th wheel to give you the auto leveling feature. The current…