Wiring Diagram for Lippert Stabilizer Jack # LC298707

Question

Question:

We need a wiring diagram for a fuse replacement that makes the lippert stabilizing jacks on the outside of the tongue of the camper work.

asked by: Sandra A

0

Expert Reply:

I have included a picture showing how the motor and switch wire up on the Lippert stabilizer jack # LC298707.

expert reply by: Jameson C

0

Diagram
(click to enlarge)

Answer 1

I attached a wiring diagram for the Solera Power Awning Switch Kit #LC285500 for you to check out.

view full answer...

Answer 2

Yes, I have attached the wiring diagram of the Replacement Electric Jack Switch with Harness #LC387874 for you to reference. Basically the Blue wire goes to a 6A auto reset breaker, like part #LC134181, which then goes to the positive circuit for…

view full answer...

Answer 3

I believe you are referring to the Lippert Components High-Speed Power Stabilizer Jack part #LC369774 that comes with the white switch part #LC144214. Lippert was not able to provide me a wiring diagram for the white switch but was able to give me…

view full answer...

Answer 4

I checked and found the manual for the Lippert Electric Trailer Jack #LC285318 and there was no mention of anything going in the hole beforehand to tighten them. I added a cut out of the manual for you which shows the parts for this jack, and it does…

view full answer...

Answer 5

Typically around the motor area of the stabilizer jack there will be a label that will have part numbers and other info listed. I attached a picture of what it looks like on the #LC298707 that you referenced. Lippert does sometimes use alternate part…

view full answer...

Answer 6

If you're looking for just the L-bracket for your HappiJac Electric Truck Camper Jack System #LC736514-ELKIT then you'll need part #LC182492. The flat bracket can be swapped out with part #LC182494 and the swing brackets can be replaced with…

view full answer...

Answer 7

I have included a picture showing how the motor and switch wire up on the Lippert stabilizer jack #LC298707.

view full answer...

Answer 8

If you take a look at the diagram I've provided for the Replacement Power Switch for RAM Electric Trailer Jack with Footplate #EJ-3520-PSW which goes to the Electric Jack w/ Footplate #EJ-3520-WBX, you'll be able to see how both of the…

view full answer...

Answer 9

For your Lippert Components Power Stabilizer Trailer Jack #LC298707 the wiring is pretty simple. There are two wires that come out of the motor and they are both used as power or ground depending on the direction you want to turn the motor. To…

view full answer...

Answer 10

On the Lippert Power Stabilizer Jack #LC298707 for your Forest River Evo Trailer Trailer there should be a 20 amp (or higher) fuse/breaker located inline with the red power wire coming from the switch before it reaches the battery. Check to make sure…

view full answer...

Answer 11

We have the 12k rated Equal-i-zer part #EQ37121ET which comes without a shank so that you could add the shank you'd need like the part #EQ90-02-4700 which fits a 2-1/2 inch hitch and has a 3 inch drop or part #EQ90-02-4900 which can do a 6 inch…

view full answer...

Answer 12

Yes, they do. The Blue Ox Sway Pro item #BLU54TR and item #BXW2003 are a couple of our most popular weight distribution systems that include the 2-1/2" shank. If you already have a weight distribution system, or want to go with a different…

view full answer...

Wiring Diagram for Lippert Stabilizer Jack # LC298707

Continue Researching