Customers compare RED35CR to these similar products
Products Featured in this Video
Speaker 1: Today we're taking a look at the Redarc plug and play wiring harness for the tow pro trailer brake controllers. This wiring adapter eases the installation of your Redarc tow pro classic or tow pro elite electric brake controller. The custom connector end plugs into the port beneath your vehicle's dash so this is a vehicle specific wiring harness. And then the other end plugs… see more >
Info for these parts were:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
On a 2017 Toyota Tacoma the location to install the #3031-P is behind the kick panel to the left of your left foot. I attached a picture. You'll need to pull off the kick panel.
view full answer...I went and pulled an Ultra-Fab T-Slot Power Drill Adapter #UF48-979071 from our warehouse to measure the inside diameter of the open end of the adapter and found that it measures .627 inches or 15.9 mm.
view full answer...Yes, the Redarc Tow-Pro Liberty Brake Controller part #RED24FR is compatible with electric over hydraulic surge brake actuators such as the ones from Hydrastar. It works with all Hydrastar actuators.
view full answer...The brake controller port for your 2019 Ram 3500 is a bit of an odd location relative to where the port is on other trucks; the port is underneath the control knobs like in the accompanying photo. You will be able to find the plug behind that panel,…
view full answer...It depends on the year make and model of your vehicle where the brake controller fuse may be located. If you have a factory towing package the fuse is sometimes labeled "trailer tow electric brake". You can check the fuse visually to see if…
view full answer...Thanks for passing that on! I attached the install video for the #C56040 on the 23 Outback you mentioned as well.
view full answer...The Curt Echo In-Line Wireless Brake Controller #C79DR is designed to be plugged in-line with your USCAR connector that pulls power from the 12 volt power pin. It is designed to be used with a standard 7-way and not a commercial 7-way. The pin-outs…
view full answer...Sounds like the brake controller wiring you found under the dash of your 2004 Dodge Ram 1500 doesn't run to the rear of the vehicle. I would be shocked if any of the circuits are active though on that connector as everything we know on your…
view full answer...Redarc does not offer longer cables between the knob and the module but we've spoken with Redarc before and they have told us that you can use a standard RJ45 network cable to extend as far as needed which you'd be able to easily source…
view full answer...The correct brake controller install harness for your 2018 Ram 1500 is the part #3024-P which it sounds like you have. Most likely you grabbed the wrong harness on your vehicle for this to plug into. Best option I have would be for you to check out…
view full answer...XM radio device compatibility can vary depending on the generation of the items. Older systems may not always function with latest-generation items. But so long as a device such as the SiriusXM Satellite Radio Receiver #292-101468 has the same…
view full answer...So far (November 2022) on the Go Power Portable Power Bank with Solar Panels #GP22RR we only have had 1 poor review about the quality of the product but upon further investigation that looks to be a defect. Go Power is one of the leading solar panel…
view full answer...