Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
There may be something out there that combines everything together but from my knowledge these are 2 different systems and I have yet to find a product that pulls info both from cameras and from a TPMS. With that being said, we do have camera systems…
view full answer...The TST TPMS for RVs with 6 Flow Through Tire Sensors #TST-507-FT-6-C are compatible with steel, chrome, or nickel valve stems. Since you have rubber valve stems you need the kit #TST-507-RV-6-C with the standard sensors instead.
view full answer...If you use your 50 amp Watchdog #HU87FR with a 50 amp to 30 amp adapter like the part #CAM55185 your RV would be protected against surges beyond 30 amps up to 50 amps so since your RV is rated for 50 amps this should be fine.
view full answer...Hey Joe! We haven't done a lot of installations on the #3460001 and I believe we tied it into a factory switch on the one we did. I would say find any open spot in the dash nearby for installation like the picture below.
view full answer...Not all aluminum trailer frames are strong enough for use with a steel weight distribution (WD) system. It is possible that the stronger steel WD components could put too much stress on the frame. If your trailer has an aluminum frame you'll…
view full answer...It can be difficult to give a truly accurate estimate for the length of time it takes to install the Custom Third Brake Light Camera for 8" Factory Monitor #3460001 on your 2020 Ford F-350 Super Duty. The time really depends on how comfortable…
view full answer...The Custom Third Brake Light Camera for 8" Factory Monitor part #3460001 could pretty easily be wired to an existing switch you have in the cab but I would not be able to offer much advice on this as it's designed to be used with the…
view full answer...The Custom Third Brake Light Camera part #3460001 which is a fit for a 2020 Ford F-150 with 8" monitor installs rather easily with only a few connections. There is a plug that ties into the factory harness and then a switch which gets run to a…
view full answer...Based on the GVWR of your 2019 Jayco North Point 315RLTS it does seem like you have 7k axles. I recommend verifying this information to be sure. These axles typically use the #14125A outer and #25580 inner bearing found in the Timken #TMK92VR.…
view full answer...Since AL-KO is no longer around, you will need to check your existing bearings to find the correct replacement. If you remove your hub you can look for the bearing numbers stamped in the face of each bearing. If these are worn or missing you can…
view full answer...It sounds like you want to use the factory monitor which is where things get a little more difficult, but there is a way. You can use the Truck Bed Cargo Camera for 8" Factory Monitor - Switch Kit #3460001 to get the factory wiring connection…
view full answer...I've seen the instructions for the Truck Bed Cargo Camera #3460001 and they are adequate but not super detailed. We do have our review video, which I've linked for you, that quickly shows you where they ran the wiring. I took a picture of the…
view full answer...Related Searches
Filter Your Search
Contact and Help