Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Dan, welcome back! We don't have much information on the Curt Trailer Hitch item #C67RJ at this time. We just know it's going to fit the 2023 Toyota Prius. That being said, I took a look at your order history and I think you've…
view full answer...Yes, what you described is exactly how to ground a trailer light that replaces a light that used to ground through the mounting hardware. Just run the ground wire to the mounting hardware and you'd be good.
view full answer...The Sealed, 2-1/2" Round Trailer Clearance, Side Marker Light with Reflector #MC57RB requires the use of a the Grommet part #A55GB to install. This grommet will require a 3 inch hole to be drilled. For a pigtail harness you would need the part…
view full answer...I'm sure we can get you a pre-greased hub assembly to replace your UFP H1377, but I was unable to find any definitive information on exactly what will replace this hub. So in order to find the correct hubs you will need to take apart your current…
view full answer...The Easy Grease Trailer Idler Hub Assembly for 3.5K Axles part #AKIHUB-545-35-G-EZ-K is a direct replacement for a UFP H-1377.
view full answer...Hey Joanne, I think I've found what you're looking for with the Surehoof Ribbed Rubber Trailer Mat #4872SM. This measures 48" x 72" which I would think is enough to cover your ramp and help your horse feel a little more comfortable…
view full answer...In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
view full answer...Hey Doug, That's a good question because fit is really important so the cover stays snug on your trailer, and there is a specific way to measure for the etrailer covers. It's pretty simple, and what you want to do is measure the body of the…
view full answer...Hey Cheryl, Yes, the Self-Contained Hydraulic Jack #e33VV could be bolted the frame of your horse trailer to upgrade you to a motorized jack. This jack has a 12,000lb capacity so you'll want to verify what your pin weight is to ensure it falls…
view full answer...I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…
view full answer...The correct bearing and seal kit for your Dexter 7,000 lb axles is going to be either the Bearing Kit part #BK3-210 which has a 2.125" seal or the Bearing Kit part #BK3-200 which has a 2.250" seal. Unfortunately, this axle could have come…
view full answer...I really wish we had the chance to install the Kat's heater #KH13150 so we could provide an install video or pictures but the best is the following written instructions: To install the heater you will first need to drain the cooling system. Then…
view full answer...Related Searches
Filter Your Search
Contact and Help