Result: spring

Hey Thomas, the most important factors for picking out a replacement leaf spring for a trailer are matching axle capacity and length. Getting the same amount of leaves in the spring pack is actually not a huge priority so I wouldn't worry too…

Hey Roland, thanks for reaching out! Overslung axles are a special order situation and we unfortunately only have standard axles here at etrailer. With that being said, you can order a standard axle that meets your specs and then use the Dexter…

Hey Scott! I've got an axle I think will work for you but I am concerned about your measurement. Our axle's are categorized by hub-face-to-hub-face and spring-center-to-spring-center measurements as shown in the diagram below. We do not go by…

Hey Scott! Yes, the ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat item #277-000164 will turn on at temps lower than 45 degrees. It has been tested and will work with temperatures as low as -32 degrees. I have linked an installation…

I really wish we had the chance to install the Kat's heater #KH13150 so we could provide an install video or pictures but the best is the following written instructions: To install the heater you will first need to drain the cooling system. Then…

Hey Dan, The info you provided does tell us a bit about the axle but isn't enough to look up what components go with with it. With it being a 3,500lb axle it's probably a generic 3,500lb kit for the bearings and seals but I'd hate to not…

Yes, the Dexter Self-Contained Hydraulic Jack #DX72CR does come with a manual hand pump that can be used as a backup in the event of hydraulic malfunction.

Easiest way to tell which gooseneck hitch you have is by looking at the safety cable loops. If they are about as wide as the gooseneck ball hole and are centered with the ball hole it's an EZr, if the safety chain loops are a smaller and offset…

You will actually just need kit #APT6SE-36 which is the same thing only the equalizers in it are 13-1/8 inches long. The hardware with each is specific to the kits so some of the other parts are different but for 2 inch slipper springs and 13-1/8…

Thanks for reaching out, Don! Your Kodiak 10" Hub-and-Rotor Assembly #KHR10D fits on a #84 Spindle like part #TRU74FR. You can swap over to the Spindle Nut Kit for EZ Lube Axles #RG05-100 which is a much more simple design. A lot of people have…

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…

The Therma Heat heating pads #277-000164 are thermostat controlled, automatically coming on at 45 degrees Fahrenheit and off at 67 degrees Fahrenheit.