Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Yes, 2-5/16 inch ball #63840 will fit Reese weight distribution system #RP66131. The shank length and diameter matches what the system requires.
view full answer...If your loaded tongue weight is 1,350 lbs then the Reese WD System part #RP66131 that you referenced would be correct for you as it has a tongue range of 800 lbs - 1,500 lbs and yours falls in that range. Be sure that you are considering the weight…
view full answer...We do have weight distribution shanks available that are designed to fit 2-1/2 inch hitch receivers like what is on your Silverado 2500. For the Reese Steadi-Flex Weight Distribution System #RP66561 that you were looking at, you will just need to…
view full answer...The Tuson Electronic Sway Control System for Electric Trailer Brakes #335TSC-1000 has installation instructions that give a placement location on the center of your trailer and 5-10 feet behind the hitch ball. The unit comes with a wiring harness…
view full answer...Yes, a trailer that is nose up can cause big problems. A level trailer is ideal and worth working toward for safety. The good news is that you can get the trailer almost exactly level with switching ball mounts. This is where an adjustable ball…
view full answer...If the trailer is less than 1 inch off of being perfectly level either up or down then it will be perfectly fine. Having it slightly higher would be better because presumably the tongue weight of the trailer will pull it down a little. You could also…
view full answer...It is perfectly safe to use a reducer sleeve like the Curt #C45405 to fit an accessory with a 2" shank into your 2-1/2" trailer hitch receiver. We do have options for you to use a ball mount with a 2-1/2" shank for when you want to tow…
view full answer...The best overall ST205/75R14 Load Range D trailer tire is from Westlake: - Westlake ST205/75R14 Radial Trailer Tire - Load Range D #274-000012 The reason the #274-000012 is the best is because of its deep 10/32" tread depth, which is the most…
view full answer...We still recommend the use of a slider in all standard/short bed trucks. That being said, the new GM trucks like your 2022 GMC Sierra 2500 do have a slightly longer bed than the typical standard bed. The best thing you can do is to measure to see if…
view full answer...Sounds like you have a friction sway control weight distribution (WD) system like the Reese Steadi-Flex #RP66561 or the Equal-i-zer #EQ37140ET. Pretty much all sway control setups use friction and that's what those loud popping and creaking…
view full answer...Well if the adapter says not to use it with a weight distribution system it would have to be that they never tested it with a WD system or they did and found that it damaged the adapter or the hitch when used. A WD system does put a different kind of…
view full answer...Between using a reducer sleeve and upgrading your weight distribution shank, I recommend going with a weight distribution shank designed to fit the 2-1/2 inch hitch receiver on your 2015 Ram 2500HD. Using a 2/1/2 inch shank, like #EQ90-02-4800, for…
view full answer...Filter Your Search
Contact and Help