Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The portion of the rear hanger with TOP labeled on it will get welded to the trailer frame. I am including a picture of the hangar that shows the top marking and how it is positioned on the trailer. I attached an FAQ on trailer suspension for you to…
view full answer...I spoke to my contact at Redline and he informed me that the dimensions of the Center Hanger part #23-43-2 are 5-1/2 inches in overall height, the outer width of the hanger from where the bolt runs through the hanger is 4-1/4 inches and the inside…
view full answer...Hey Will, thanks for reaching out. What I recommend for replacing your 7-way is the following: - etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector #e99011 Wiring your connections thru the junction box helps keep them…
view full answer...The distance between the spring eyes on center for #e54SR is 25-1/8 inches. When using hanger kit #APS5 the distance on center between the hangers with this spring is 25-3/4 inches, a 1/2 inch longer. This is correct. The hanger spacing should be…
view full answer...Spring hangers are intended to be welded on. Although you could drill holes in them and bolt them to your trailer, this would affect their capacity to some unknown degree and so this is not recommended. A local trailer supply shop will be able to do…
view full answer...For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…
view full answer...The correct nut for the Dexter Shackle Bolt for Double Eye Springs part #007-126-01 is the Replacement Flange Nut for Dexter Trailer Suspension Kits part #006-092-01.
view full answer...The #SP-210275 you were looking at is for a 3500lb axle and is 27" long measured from center of spring eye to center of spring eye. This is the correct spring for your trailer based on the measurements you provided. The next shortest spring…
view full answer...Hello Kevin, thanks for reaching out. Since you have already driven with these brakes a lot, the shoes should be properly seated to the drum. New breaks do need to be broken in to get full braking power. This is usually done by speeding the truck up…
view full answer...First thing I'd check is to see if the spindle nut is on too tight. If the brakes are tensioned properly and there's still more drag on one when than the other most likely somebody tightened the spindle nut too much. The spindle nut needs to…
view full answer...The only tank equipped RV water heat option we currently offer is the Dometic RV Water Heater part #DMC74FR which is a 120 volt unit with 6 gallon tank and gas/electric operation. In regards to installation, this must be performed by a qualified…
view full answer...I have a solution for you, but we do not have a double lip grease seal with the exact measurements you specified. However I was able to find out that the GS-1250 DL that you mentioned has the following measurements: Inside Diameter: 1.249"…
view full answer...