Replacement Hub For a 2004 Jayco Qwest Camper
Updated 04/22/2026 | Published 04/16/2026
Products Featured in This Question
Question:
I have a 2004 Jayco Qwest and planning on buying 3 replacement tires. Taskmaster 5.30R12 Radial Trailer Tire w/ 12 Vesper Silver Mod Wheel - 4 on 4 - LR C. My question is I need to redo my single axel bearing and grease and wondering if you can help me know what I need to buy. To do this project. Thanks
asked by: Jeff S
Expert Reply:
Hey, Jeff. Thanks for reaching out.
Since your trailer has a 4 on 4 bolt pattern, there are two common bearing setups it could be using, so we’ll want to narrow that down.
One option is a 1" straight spindle, which would use bearing # L44643 for both the inner and outer. A good match for that setup would be the Easy Grease Trailer Idler Hub Assembly # AKIHUB-440-2-G-EZ-1K.
The other possibility is a slightly larger 1.063" spindle, which uses bearing # L44649. For that setup, you’d be looking at the Trailer Idler Hub Assembly # AKIHUB-440-2-G-2K.
The easiest way to confirm which one you have is to either check the numbers stamped on your existing bearings or measure the spindle where the bearings sit.
Once you’ve got that confirmed, I can help you make sure you’ve got the right seals, grease, and any other parts you’ll need to get everything back together.
What camping trips do you have lined up for the year so far?
(click to enlarge)
Product Page this Question was Asked From
Easy Grease Trailer Idler Hub Assembly for 2K Axles - 4 on 4 - Galvanized
- Trailer Hubs and Drums
- Idler Hub
- EZ Lube
- L44643 / L44643
- Marine Grade
- For 2000 lbs Axles
- 1/2 Inch Stud
- 4 on 4 Inch
- 8 Inch Wheel
- 10 Inch Wheel
- 12 Inch Wheel
- 13 Inch Wheel
- 14 Inch Wheel
- etrailer
more information >
Continue Researching
- Q&A: Replacement Hub for 1" Straight Spindle on Boat Trailer
- Q&A: Is there a Trailer Wheel that Fits a 4 on 3 Inch Bolt Pattern
- Q&A: Can I Replace Bolt-On Spindle With Weld-On Spindle
- Q&A: How to Tell if Trailer has a BT8 or BTR Spindle Installed
- Q&A: Recommended 5.30-12 Tire And Wheel Combo For A John Boat Trailer
- Q&A: Replacement Dexter Hub for 8-91A Hub
- Q&A: What 4.80-12 Tire on Galvanized Wheel do You have for My Boat Trailer Used on Sometimes Saltwater?
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Measure a Trailer Axle
- Article: Trailer Wiring Diagrams
- Article: Most Popular Wheel Bearings
- Article: How To Measure And Replace Everything In Your Hub Assembly
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Tell the Weight Rating of a Trailer Axle
Bill
4/22/2026
I put them on a old COX pop up camper axel . They are a perfect fit . I think it's a 1500 to 1800 lb axel , it had 4 wheel studs on it from the factory .