What Are The Wires On The Demco Coachlink Transmitter For?

Question

Question:

There are two wires on the Coachlight monitor!, one is power from the battery and where does the other one go?

asked by: Joseph T

0

Expert Reply:

Hello Joseph, thanks for reaching out. For the coachlink transmitter the white wire is ground, and the red wire goes to the reed switch. I've included a diagram showing an example of how that would be wired up. Hope this helps!

What coach are you installing this on?

expert reply by: Jesse M

0

coachlink transmitter diagram
(click to enlarge)

Answer 1

Hey Neil. The 18,000 Btu Furrion Chill Cube RV Air Conditioner item #LC34DX fits a 14-1/4" x 14-1/4" cutout which is pretty standard on RV's. If you meant to write Dometic instead of domestic then yes it'll fit in your existing…

view full answer...

Answer 2

Depending on the lighting for the Bronco your brake light relay wire might not be useable. Models without the signature LED lighting will have a purple wire for the brake light, while models with the signature LED lighting will not have an accessible…

view full answer...

Answer 3

I was able to verify with Demco the red wire on the Coachlink #SM99945 for the Demco Stay-IN-Play #DM86VR is positive and the black is negative.

view full answer...

Answer 4

I spoke to my contact at Yakima and she confirmed that the weight capacity for the Yakima Hold Up 4 #Y02443-2 is 60 lbs per bike with an overall capacity of 200 lbs.

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

Thanks for the information Kevin! To flat tow your 2025 Ford Bronco with a standard bumper and LED lights, I recommend the following parts: Tow Bar and Safety Chains - etrailer XHD Non-Binding Tow Bar for Roadmaster Direct-Connect item #e84ZR Base…

view full answer...

Answer 10

Hey Matt, Furrion typically has 4 wires running to their thermostats and the Chill Cube Thermostat #LC74DX is no exception. The harness you see with the thermostat would plug into the Chill Cube's controller and has 4 wires to extra wire to to…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

What Are The Wires On The Demco Coachlink Transmitter For?

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching