Availability of Amber Version of TecNiq PCP2 Side Marker Light

Question

Question:

I have an amber side marker light on the fender of my boat trailer that needs replacing. I would like to do a direct replacement with the one that I already have, and best as I can tell, it is just like one you have listed TN73TR, but it has an amber lense instead of a red one. Do you have that same Techniq stainless steel marker light in amber instead of red?

asked by: Amber S

0

Expert Reply:

The closest light we have to the part # TN73TR that is amber would be the part # TN23TR which is very similar but has a slightly different mounting design.

expert reply by: Jameson C

0

Jameson C.

10/22/2025

Hey, how did the TecNiq amber side marker light end up working on your boat trailer? Your update could make it easier for others trying to match the same stainless steel style.

Answer 1

Our installer here will spray the light with some lubricant around where the light meets the grommet and then will use a screwdriver to pry the light out first, and then the grommet. If you check out the install video I attached you will see this…

view full answer...

Answer 2

To remove the Lens #A44RB from the LED Clearance or Side Marker Light #MCL40RB you will need to place the tip of a flat head screwdriver between the lens and light assembly(see image). I recommend starting near the corners to reduce the risk of…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Availability of Amber Version of TecNiq PCP2 Side Marker Light

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching