Hey Jamie! I can definitely help you out. The Square Direct Weld Jack #e66FV is nearly identical to your 0091410 and can be used to replace it. This is a 4" square weld-on jack with the same lift and capacity so you won't even notice a…
Hey Joe, The Dexter Swing-Away Coupler #DX53CR is made out of a steel construction, not cast iron. So none of the item itself is a cast iron material. Are you specifically looking for one that is?
The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…
I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…
To correctly measure a leaf spring, you'll want to jack the trailer up on jack stands so the axle is hanging freely, then measure directly across from the center of one spring eye to the other, as shown in the provided diagram. The height of the…
Rhino Rack offers versions of their Pioneer Platforms that fit aero bars with the part #RR42114BF for a 48 inch by 38 inch platform or the part #RR42115BF which is 58 by 47 inch.
The Rhino Rack Pioneer Platform Rack #RR42114BF inlcudes mounting hardware that will allow you to mount the rack in the T-slots of your vortex aero bars or wraparound the bars with the clamp mount. I've linked our review video of the product that…
You could use pvc pipe and secure it to the frame of the trailer, but that is way overkill and way more work then you need to do to protect the wires. I would just get some wire loom the correct size for however many wires you have to run, and some…
It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…
The light dimensions of the Optronics LED #TLL12RK are 7-9/16" long x 2-3/4" tall x 1-3/4" deep and the hole size needed is 6.75" by 2.5 inches. I confirmed this with my contact at the manufacturer and I've attached a template…
90-120 ft lbs of torque is probably about right for your trailer rims. If you check out the lug nut torque chart that I attached you will see that nearly all of the torque specs are that and higher.
Hey Scott, thanks for the pictures! To replace your Klauber 500 series slide-out motor you'll need the Lippert RV Slide-Out Motor by Klauber item #LC130057. Does your motor have a connector at the end of the wires or are they spliced in?
Filters
