Finding The Correct Replacement Landing Gear for a 2010 Palomino Puma 5TH Wheel Camper
Updated 02/17/2026 | Published 06/23/2024
Question:
trying to make sure I get right landing gear.have a 2010 palamino puma made by forest river 5th wheel. one broke just trying to make sure get right ones
asked by: Jason F
Expert Reply:
As I have no way to look up what parts were installed on your 2010 Palomino Puma I would need for you to either check the jacks for a tag with information on the jacks. Or you will need to measure the the landing gear square tube lengths along with the distance between the notches which sit at the clamps which hold it on your frame. With this I can look for just the legs so you will not need an entire System # RVLG-8HDL like you were looking at.
Product Page this Question was Asked From
Landing Gear Set w/ Handle - 36-1/2" Lift - 8,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Landing Gear
- Steel
- 7001 - 8000 lbs
- Manual Jack
- 36 Inch Lift
- Weld-On
- 2 Jacks
- etrailer
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Curt Spectrum Trailer Brake Controller w/ Plug-In Harness - Up to 4 Axles - Proportional
- Shop: Brake Controller
- Shop: Stromberg Carlson Electric Landing Gear Set - Weld On - 34-7/8" Lift - 6,500 lbs
- Shop: Replacement 5th Wheel RV Landing Gear Follow Leg w/ Snap Pin for RVs
- Q&A: Replacement Landing Gear Legs Needed for a 2004 Arctic Fox 29.5E 5th Wheel Trailer
- Q&A: Where to Measure To Determine if Lippert Landing Gear Jack part # LG-1 Fits Trailer
- Q&A: How to Determine the Correct Jack Height and Lift Needed for Replacement Trailer Jack
- Q&A: Recommendations For Complete Fifth Wheel Landing Gear For 2004 Jayco Eagle
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Search Results: brake harness
- Shop: Camco Cyclone RV Plumbing Vent
- Shop: Replacement Mounting Hardware for Go Power Rigid Solar Panels
- Shop: Trailer Hitch
- Search Results: trailer hitch
- Video: How to Choose a Trailer Brake Controller
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Video: A Look at the Power Mountain Tallboy 6 Ton Off-Road Bottle Jack with a Military Cargo Trailer
- Search Results: trailer wiring
- Shop: Suspension Enhancement
- Video: Redarc Tow-Pro Liberty Brake Controller Review RED24FR
- Shop: Redarc Tow-Pro Liberty Brake Controller w/ Universal Wiring Harness - Dash Knob - Proportional
- Q&A: Recommended SnapPad Jack Pads for a HWH Leveling System on a Motorhome
- Search Results: trailer tires and wheels
- Article: How to Measure for Trailer Hitch Drop
- Search Results: trailer jack
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
on Camper Jacks
Jesse M.
2/17/2026
Hey, were you able to get the measurements from your Palomino Puma’s landing gear? Once you have those details, I can help confirm which legs will match your setup. Let me know what you find so we can narrow it down.