Replacement Extend/Retract Switch for Older Lippert 1817941 A-Frame Trailer Jack

Question

Question:

I need to know if this switch will fit the Lippert leveling jack, model # 1817941?

asked by: Mike A

0

Expert Reply:

Yes, the RV Landing Gear Switch # 37213635 will fit your older Lippert 1817941 A-Frame trailer jack.

expert reply by: Jon G

0

Answer 1

The old Reese V-5 weight distribution system is not rated by the vehicle. It will be compatible with vehicles and trailers determined by the loaded tongue weight of the trailer along with any any cargo behind the rear axle of the towing vehicle.…

view full answer...

Answer 2

Since you have the pucks pre-installed, you won't need the install kit or anything else. You would simply remove the covers over the pucks in your truck bed and drop in an M5 Series fifth wheel hitch like the #RP30921 for an 20K capacity. B&W…

view full answer...

Answer 3

To replace the extend/retract switch on your Lippert 181794 Electric Trailer Jack you'll simply need the Replacement Extend/Retract Switch for Lippert Electric Trailer Jack #LC49MD. If you're needing to replace the on/off or just both…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 7

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 8

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 9

Hey Jon, happy to help. Yes, I was able to find the replacement parts to #BM44YR. The 90 degree angle #BM99RR and the check valve #BM98GR have 1/2" MPT fitting that connect directly to your B&B RV Water Center. So no worries about…

view full answer...

Replacement Extend/Retract Switch for Older Lippert 1817941 A-Frame Trailer Jack

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching