Correct Replacement Magnets for Electric Trailer Brake Kit - 10" - 3,500 Lbs
Updated 10/17/2022 | Published 10/15/2022 >
Products Featured in This Question
Question:
Im looking for the replacement magnets for this particular drum and hub setup. I purchased this order in April of 2017. Just recently my brake controller started saying output shortage no break. I have narrowed it down to the back axle and have redone all wiring up to that point and including that point. When all hooked up I still get that message but when I cut the wire at that last axle it returns to normal. This makes me assume that I need to replace the magnets inside of the drum as per previous comments on this site. If that is correct I need to know the part number and when I can have it ordered and shipped. Thanks my previous order would be under Wayne bergstresser and was in April 13th 2017.
asked by: Eric B
Expert Reply:
I looked up your order and found out you have the Electric Trailer Brake Kit part # AKEBRK-35-SA and the correct replacement magnets for these are the Replacement Magnet Kit for 10" Electric Trailer Brake Assemblies part # AKBRKR-M10.
Product Page this Question was Asked From
etrailer Electric Trailer Brakes - Self-Adjusting - 10" - Left/Right Hand Assemblies - 3.5K
- Trailer Brakes
- Electric Drum Brakes
- Standard Grade
- Self Adjust
- 10 x 2-1/4 Inch Drum
- 3500 lbs Axle
- 13 Inch Wheel
- 14 Inch Wheel
- 15 Inch Wheel
- etrailer
more information >
Continue Researching
- Q&A: Which Trailer Brake Magnets Do I Need to Use
- Shop: Replacement Magnet Kit for 10" Electric Trailer Brake Assemblies - 3,500 lbs
- Shop: Dexter Electric Trailer Brake Assembly - 10" - Left Hand - 3,500 lbs
- Shop: Replacement Trailer Brake Magnet Kit for Dexter and Hayes / AL-KO 10" Trailer Brakes
- Shop: Suspension Enhancement
- Shop: Air Lift Ride Control Air Helper Springs - Rear Axle
- Shop: Brake Controller
- Article: Testing Trailer Brake Magnets for Proper Function
- Search Results: akebrk~35~sa
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Video: Feature Review Replacement Magnet Kit for 10" Electric Trailer Brake Assemblies
- Video: Remove and Reinstall a Trailer Hub Review
- Video: Hands-On with the Air Lift Ride Control Air Helper Springs
- Q&A: What is the Bolt Pattern for Dexstar 15x5JJ Trailer Wheel 17-384
- Shop: Channel Tongue Trailer Coupler - Trigger Latch - Zinc - 2" Ball - Bolt On - 5,000 lbs
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Search Results: trailer brake tester
- Shop: etrailer Electric Trailer Brakes - Self-Adjusting - 10" - Left/Right Hand Assemblies - 3.5K
- Shop: Tekonsha Primus IQ Trailer Brake Controller - Up to 3 Axles - Proportional
- Search Results: brake controller tester
- Search Results: replacement trailer brake magnet
- Search Results: break away switch
- Q&A: Installing a 7-way Trailer Connector On 2010 Nissan Xterra with Existing 4-way Connector
- Q&A: Troubleshooting Trailer Brakes Getting Only 8 Volts Of Power
- Q&A: Should The Trailer Brake Circuit Have Continuity Between the Blue Power Wire and Ground?
- Q&A: Troubleshooting Trailer Brake System That is Only Showing 5-Volts at Trailer Connector
- Q&A: How to Test Brake Controller without Trailer Connected
- Search Results: spindle nut
- Search Results: hitch coupler
- Article: Trailer Lighting Requirements

