Step Motor Replacement For Kwikee 32 Series Steps in 2003 Motorhome

Question

Question:

I have a kwikee step motor that needs to be replaced, 293572 Series 32 and i do not find this series anywhere on your sight or others. can you help me, possibly need to upgrade the motor but to which one? it is on my 2003 Fleetwood Excursion. 2 step. Thanks for your help

asked by: Carrie J

0

Expert Reply:

Thank you for the photo and there is an option to replace the motor on your Kwikee 32 Series steps, though you'll need a full upgrade kit to the new style of motor:

- Motor Upgrade Kit for Kwikee Electric RV Steps # LC29VR

expert reply by: Kyle S

0

Older Kwikee Series 32 Motor
(click to enlarge)

Answer 1

There are indeed many different replacement step controllers out there and I am happy to re-confirm that the correct current item to replace your Kwikee step controller 1800709 is part #LC363989. I verified this item with my parts contacts at…

view full answer...

Answer 2

I spoke to Lippert and confirmed the Motor Upgrade Kit for Kwikee Electric RV Steps part #LC29VR is confirmed for the Kwikee Steps 90230825.

view full answer...

Answer 3

I'm not entirely sure what the difference is between the old and the upgraded controllers aside from the fact that the old model doesn't have a direct replacement. They made a change to the steps after 2005 moving to the integrated system…

view full answer...

Answer 4

This radio is no longer manufactured. Assuming this is the dash radio, then this is in a "1.5 Din" sized opening. The Magnadyne website has a user manual PDF with the wiring schematic. I would replace this Magnadyne radio with the Jensen…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Step Motor Replacement For Kwikee 32 Series Steps in 2003 Motorhome

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching