Correct Steering Stabilizer for a 2002 Workhorse W-22 Chassis

Question

Question:

What mounting bracket is needed for stablizer? W22 workhorse

asked by: Mike G

1

Helpful Expert Reply:

I checked with Roadmaster and the correct Roadmaster Exact Center Steering Stabilizer for a 2002 Workhorse W-22 Chassis is part # RM32RR for GVWR's over 22K or part # RM88RR for GVWR's under 22K.

expert reply by: Conner L

1

Answer 1

I looked up your 2018 Jayco Alante 26X and the towing capacity looks to be 5,000 lbs and the GVWR is 16,000 lbs. The GVWR is the amount of weight the vehicle can weigh total at it's capacity. So that would indicate that if you had the vehicle…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 5

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 6

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 7

Hey Dan, welcome back! I'm assuming this is for the same 2025 you asked about before. The Safe-T-Plus Steering Stabilizer #ST98MR is what you need. This is designed to fit a Class C E-450 and comes with the custom mounting brackets. How are you…

view full answer...

Answer 8

Hey Gary, welcome back! The Safe-T-Plus #ST88MR is spring-based and reactive, so it corrects steering after you start to drift. It’s simple, solid, and proven. The steering will be firmer with this system installed, so if that is what you prefer I…

view full answer...

Answer 9

Hi James, The Safe-T Plus Steering Stabilizer part #ST98MR you were looking at is a great choice for your 3010DS Forest River! The Safe-T-Plus has had some great feedback and people prefer the feel of it over other systems when driving for keeping…

view full answer...

Correct Steering Stabilizer for a 2002 Workhorse W-22 Chassis

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching