Replacement Roof Flange For A MaxxFan Deluxe Model 05301K

Question

Question:

I need a replacement roof flange and the metal mounting clips. My model of fan is the 5301k. Is the MA49FR the correct flange for my model and does it come with the metal mounting clips?

asked by: Charles P

0

Expert Reply:

That is correct, the correct replacement roof flange for your MaxxFan Deluxe Roof Vent # MA00-05301K is the Replacement Roof Flange Assembly for MaxxAir Maxxfan Deluxe RV Roof Vent # MA49FR.

expert reply by: Bryce D

0

Answer 1

To install a roof vent lid like the Replacement Lid for MaxxAir MaxxFan Deluxe #MA05-30510 for the MaxxFan Deluxe Roof Vent w/ 12V Fan #MA00-05301K, isn't considered to be a difficult task at all. The unit does not have to be removed from the…

view full answer...

Answer 2

When it comes to trimming The Ceiling Garnish for MaxxAir MaxxFan RV Roof Vent #MA54FR you will need to use masking tape to mark where you want to make your cut on the garnish. You will then need to use a hand saw to cut along the masking tape. I…

view full answer...

Answer 3

Use masking tape to mark where you want to make your cut on the Garnish part #FVK2040-80 and then use a hand saw to cut along the masking tape.

view full answer...

Answer 4

It sounds like you are looking for the Ceiling Garnish for MaxxAir MaxxFan RV Roof Vent - White #MA54FR. This will slide up into the ceiling opening for your MaxxFan Deluxe Roof Vent w/ 12V Fan, Thermostat, and Remote - Powered Lift - 10 Speed -…

view full answer...

Answer 5

When it comes to replacing the roof flange assembly on your trailer we sell The Replacement Roof Flange Assembly for MaxxAir Maxxfan Deluxe RV Roof Vent - White #MA49FR. We do not sell the metal clips individually. You would have to buy the whole…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 12

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Replacement Roof Flange For A MaxxFan Deluxe Model 05301K

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching