Troubleshooting Lipper Leveling System That Has Flashing Lights And Warnings

Published 08/31/2021

Products Featured in This Question

Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set

(123)

$3439.68

Replacement Control Panel for Lippert Ground Control 3.0 and Travel Trailer RV Leveling System

(140)

$329.90

Question:

on lippert control panel all the lights are flashing on and off wait, jack down, low voltage ect..

asked by: John S

Expert Reply:

You will want to tell me your model number so that I can accurately determine any possible solutions. That said, I was able to pull some info from Lippert's popular leveling systems to get you started. It is possible that your battery voltage is lower than optimal level, which could cause some of these warning lights. I would first make sure the battery is in good working order. Next step would be to reset your system. If you have a 2009 - present Lippert leveling system then to reset the system you would just push all 4 diamond-shaped jack buttons at the same time.

If you actually have something like the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System # LC358590 which uses Control Panel # LC421484, then this is the process to reset:
1. Press the “CONNECTED” icon at the top of the leveling screen quickly 6 times. Wait a few seconds until the gear icon with "OPTIONS" appears
2. Press the gear icon with "OPTIONS"
3. The screen will show "SET UP: Zero Mode Press Enter"
4. Press the “Enter button”
5. The touch panel will present options for further leveling of the trailer if needed. The screen will also state "ZERO POINT CALIBRATION - Press Enter to Set"
6. Press "ENTER"
7. Screen will show "Zero Point Stability Check ... Please Wait", followed by "Zero Point Set"