Troubleshooting Lippert Ultra Level Hydraulic System That Has All Lights On Panel Lit

Question

Question:

On my lippert panel all lights are on from WAIT down. Can you help me with that? I’m trying to get my coach up and going so I can drive it and park it for my sons youth camp for church.

asked by: Sue E

0

Expert Reply:

I checked with Lippert and they gave me the following instructions for your Ultra Level to clear the code you have:

In order clear this error, press and hold all 4 directional buttons as once for 3-5 seconds. If this error comes back, check fluid level, breaker between pump and battery and then finally pressure switch.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The Furrion Chill HE Replacement RV Air Conditioner Unit for Furrion Setup #FR58PR can be used with ducted and non-ducted systems, you'll just need to check the connection type for your current roof top unit to see if you would need to change the…

view full answer...

Answer 2

You're already on the right track with everything you looked at. Your 2018 Thor ACE 30.3 has a GVWR of 18,000 lbs so I recommend the following: -Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets for Class A Motorhomes #RM33RR…

view full answer...

Answer 3

I spoke with my contact at Lippert and he informed me that the lights flashing indicate the low point of the coach and that if you perform a zero point calibration you will correct that. In the service manual you will need to follow the instructions…

view full answer...

Answer 4

I reached out to my contact at Lippert and they said that it sounds like you just aren't holding the 4 buttons for the reset long enough. It requires 5 seconds, but many people will count to 5 a little too fast and the system won't reset. He…

view full answer...

Answer 5

In order to test the controller on the Lippert Ground Control 3.0 Electric Leveling System you'll first need to obtain a multimeter. Once you have this then you will need to use the ground probe and place that on the green wire coming from the…

view full answer...

Answer 6

Hey Craig! Is this a Lippert Ground Control system? Is the part actually 304136? I asked Lippert and they said they don't have anything under 304135. If it is the 304136 the correct replacement is the Replacement Control Module for Lippert Ground…

view full answer...

Answer 7

Hey Michael, thanks for the picture of the panel you are looking for. We do have that as a replacement if needed with the part #LC421484. Usually the issue you are having is that the panel does need to be replaced but may as well keep troubleshooting…

view full answer...

Answer 8

We have checked in the past with Lippert and the correct replacement module for the 694656 that you have is the part #LC304136.

view full answer...

Answer 9

Hey Rich, thanks for reaching out. Yes, you can transfer your Demco Auto Slide hitch from your Ford truck over to your new Chevy. Ford and Chevy use different puck system footprints though, so you'll need to replace the side plates with ones made…

view full answer...

Answer 10

There may be a bunch of different reason why your Lippert Level-Up system has suddenly stopped working. The most common reasons are due to a dead battery, extending your jacks too far, or a blown fuse. The first thing you should check for is the easy…

view full answer...

Answer 11

Hey John! The correct replacement control module for your Lippert Ground Control 3.0 #LC358590 is the Replacement Control Module for Lippert Ground Control 3.0 Electric Leveling System #LC304136. What kind of trailer do you have?

view full answer...

Troubleshooting Lippert Ultra Level Hydraulic System That Has All Lights On Panel Lit

Product Page this Question was Asked From

Continue Researching