Installing a Brake Controller on a 2017 Tiffin Breeze

Updated 04/21/2021 | Published 04/19/2021

Products Featured in This Question

(66)

$14.36

Question:

I understand that Tiffin prewired a brake controller connector for their 2107 Tiffin Breeze 32BR. What connector would I need to utilize the prewired connection?

asked by: Larry S

Expert Reply:

From what I could find out about the 2017 Allegro Breeze, the wires for a brake controller are indeed run, but there is no port to just plug into. To install the Tekonsha Prodigy P3 # 90195, which is a fantastic option, you would need to hardwire the included pigtail to the RV. This is not as daunting as it sounds though. Tiffin may be able to tell you which wire handles which function, but if they are unable to, you will need to test the wires under the dash with a circuit tester like the # PTW2993. The needed wires should be clustered together in a bundle of 4 wires. You would then match them to the brake controller's pigtail.

Black Wire: 12 Volt Power
Blue Wire: Power Output to Trailer Brakes
Red Wire: Cold Side of the Stop Light Switch
White Wire: Ground

expert reply by: Lazer S