Availability of Grease Cap that Fits Bore of 2.43 inch

Question

Question:

What size bearing seal do I need for a brake drum that the inside bore measures 2.43 ID? Not talking about the outside cap, which is 2.043 ID. I need a seal for the large inner bearing.

asked by: Brent C

0

Expert Reply:

Are you maybe asking about the grease cap? I believe you are since a very common size is 2.44 inch like the part # RG04-080.

expert reply by: Jameson C

0

Answer 1

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Welcome back Jordan! I have an alternative for you but we do not have any Ram 7k jacks that can be bolted on. Just welded like item #TJD-7000S and pipe mount like item #TJDP-7000S-B options. For a 7,000 lbs capacity square jack that can be bolted on,…

view full answer...

Answer 4

Hey Scott! The correct bearing kit for your Dexter 6k axle is the Bearing Kit, 15123/ 25580 Bearings, 10-36 Seal #BK3-100. If you want the Dexter version it is the #DX26ER. What kind of trailer do you have?

view full answer...

Answer 5

It sure can Hiroshi! The Active Controls ActiveStart Plug-In Soft Start for RVs item #AS94FR can be connected to a 50 amp service using the Mighty Cord RV Power Cord Adapter item #A10-5030FBK. It's extremely common for people to use a 50 amp…

view full answer...

Answer 6

Hey Peter, do you have a Lippert Ground Control leveling system on your Keystone Montana? If so, the part number you mentioned most closely corresponds with the replacement right rear leg part #LC428493. If instead this is a standard landing gear…

view full answer...

Answer 7

Hey George, honestly not much really. The Timken brand like the seal part #TMK98ZR used to be associated with being made in the USA and higher quality but they aren't made in USA any longer so between that and the part #RG06-070 there's not…

view full answer...

Answer 8

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 9

Ron, you’ll be fine with two people. Each Thomas Payne Rest Easy Trifold Loveseat - whether it’s the Dellmead #TP49KR, Driftwood #TP69KR, or McCoy #TP79KR - weighs around 153 pounds, and it ships in two manageable sections (the base and the back), so…

view full answer...

Answer 10

It sounds like you need the Dexter Wheel Bolt #7-262. This bolt measures 2-11/16" long from the base of the head to the threaded end. It has the same 1/2"-20 thread pitch and the 0.54" knurled end. The Studs #RG03-080 you found have…

view full answer...

Availability of Grease Cap that Fits Bore of 2.43 inch

Product Page this Question was Asked From

Continue Researching