How Does Stand Off Brace SPN416 Attach to RV Ladder and RV Wall
Updated 05/26/2020 | Published 07/15/2019
Question:
How does the stand-off brace hold in place?
asked by: Robert W
1
Helpful Expert Reply:
I attached a picture that shows how the Stand Off Brace part # SPN-416 attaches to both the ladder and the RV wall. Basically a single screw holds the ladder to it and then 4 screws hold it to the RV wall.
expert reply by:
Jameson C
1
click to enlarge
Product Page this Question was Asked From
Replacement Standoff for Surco Exterior RV Ladders - Qty 1
- Accessories and Parts
- RV Ladders
- Support Peg
- Surco Products
more information >
Continue Researching
- Article: How to Drain an RV Water Heater
- Q&A: Ladder Standoff Replacement with Square Base
- Q&A: What Does The Reese Replacement Spring 30776 Do?
- Q&A: Dimensions of Surco Replacement Ladder Section SU77VR To Identify If Correct Replacement
- Q&A: Brake Assemblies for 2002 Cedar Creek
- Q&A: Replacement Support Pegs for RV Exterior Ladder
- Q&A: Need Additional Stand-Off Brace for Surco Universal Exterior RV Ladder # SP502L
- Q&A: Replacement Exterior RV Ladder for 2006 Tiffin Phaeton Motorhome
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)
- Article: Can You Flat Tow a Ford Escape?
Chuck H.
5/24/2020
When the stand-off brace connects to the trailer with the screws, isn’t there some type of gasket or silicone material between the trailer wall and the brace? Thanks