Difference in Tape Sizes for Trailer Conspicuity Tape Reflectors

Published 01/19/2018

Products Featured in This Question

Optronics 6" Long Silver/ 6" Long Red Conspicuity Reflective Tape - 150' - Perforated

(468)

$135.86

7" Long White/ 11" Long Red Conspicuity Reflective Tape - (8) 18" Strips

(467)

$24.94

Question:

In what instances would I need to install a 6/6inch vs. a 7/11inch tape?

asked by: Rolando

Expert Reply:

If you check out the help article I attached below you'll see info on when conspicuity tape is needed like part # RTR15066PB for 6 inch by 6 inch or part # RE18T for 7 inch by 11 inch. The size differences basically come down to what best fits the trailer, but here is more on that:

Red and White Marking Tape

Each segment of red or white marking tape must be from 6" to 18" long.
Shorter lengths can be used to clear obstructions.
Longer lengths can be used to avoid placing white tape near red lights.
In a continuous strip of alternating red and white, the total length of 1 color cannot be more than 2/3 of the total length of the strip.
Example: If you apply tape in a 9' long section, the total length of red tape - when added together - cannot be greater than 6' because 6' is 2/3 of 9'.

Reflectors Used in Place of Tape

Reflectors must be installed in a repetitive pattern of 2 or 3 white reflectors alternating with 2 or 3 red reflectors.
The center of each reflector cannot be more than 4" from the center of each adjacent reflector.
Additional reflectors are not required if the conspicuity material is placed at the locations of the required reflectors.