7-Way Replacement for 2009 Volkswagen Touareg

Question

Question:

When I do a google search for Volkswagen 7pin connector 7L0055305N, this Pollak connector shows up several times in my results. Will this connect with the OEM harness on a 2009 VW Touareg?

asked by: Brian A

1

Helpful Expert Reply:

I did some checking and it looks like the Volkswagen 7-way you mentioned uses the same style of round connector that the part # PK11893 is designed to connect to so it would fit and work well.

expert reply by: Jameson C

1

Answer 1

I recommend the Bauer Products European Style RV Entry Door Lock #BA38AR to replace your Bargman L400. Since there is not a direct bolt on replacement for the Bargman L400 you will need to fabricate a panel to cover the larger hole on your door and…

view full answer...

Answer 2

The BLT-999A-7 code you have comes back to a Paramount fireplace with 24.8" L x 18.5" H x 8.7" D cutout dimensions. The closest option we currently have is the Greystone 26" Electric Fireplace with Crystals #324-000068 which…

view full answer...

Answer 3

I have some wiring adapter options for you, but if your vehicle has a 4-Pin round connector, like #PK11404, we only offer adapters to connect to 4-Way flat trailer connectors and tow bar wiring extensions like #HM47043 that you referenced. If…

view full answer...

Answer 4

Hi Jerry; do you have factory raised rails on your 2009 Honda Pilot? If so, you can use a roof rack like the Malone #MAL84AR. This has a capacity of 165 lbs so it will be able to handle the tent. Static capacity is never listed so I would check to…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 12

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

7-Way Replacement for 2009 Volkswagen Touareg

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching