Do the Etrailer Camper Jacks # TJ01RT-HD Come with Mounting/Installation Hardware?

Question

Question:

TJ01RT-HD. Installation hardware included?

asked by: James M

0

Expert Reply:

The Stabilizer Jacks - 6-1/4" Drop Leg Travel - 18" Extension - 650 lbs - Qty 2 # TJ01RT-HD does not come with installation hardware. The two stabilizer jacks do come with the steel rod and the bolt holes to mount are 7/16 inches in diameter and are 3 inches on center.

expert reply by: Jason S

0

Answer 1

The MaxxAir Mini Deluxe Trailer Roof Vent, #MA00-03851 was not designed for side mounting. You can of course attempt to but I suggest you first consider the MaxxFan Dome Plus Roof Vent, #MA00-03810B as this product was designed for either rooftop or…

view full answer...

Answer 2

We carry a few different weld-on camper jacks to help stabilize your trailer and allow you to easily get your equipment off the trailer. The real question is going to be how long of a jack do you need? The Square Drop Leg Stabilizer Jack - 18"…

view full answer...

Answer 3

The fully extended length of the #TJ01RT-HD stabilizer jack would be 18 inches, which represents the 'A' Dimension in your photo. The 'B' dimension would simply be the height above the ground of the underside of your trailer when its…

view full answer...

Answer 4

Quality-wise there isn't much of a difference between the etrailer.com stabilizer jacks part #TJ01RT-HD and the Stallion Stabilizer Jacks #288-01892-2 that you also mentioned. I'd recommend going with the kit that matches the height…

view full answer...

Answer 5

Hey Tim, Yes, the 4 1/2 is considered the bolt spacing in that bolt pattern. The 5 lug wheels are a bit tricky to measure, and a lot of times are measured wrong. I am going to attach a link to a help article that walks you through how to measure a 5…

view full answer...

Answer 6

To install the Stabilizer Jacks - 6-1/4" Drop Leg Travel #TJ01RT-HD you'll need to get 7/16" mounting hardware. In the attached review/installation video we use #14 self-tapping screws to mount these jacks into the frame of the trailer.…

view full answer...

Answer 7

Hey Tom, The etrailer stabilizer jacks #TJ01RT-HD are going to be the shortest that we have at 11-1/2" fully retracted. We do not carry any that are shorter than that. Now when they are retracted the are able to fold up for storage so they are…

view full answer...

Answer 8

Hi John, That sounds really cool! Let me see if I can help you make that vision come true. The patio kit you mentioned, part #LC27FR, is actually the only full "patio kit" we carry — but I’m afraid it might be a little too wide for your…

view full answer...

Answer 9

Hey Lyn! The Malone Crossbar Conversion Kit for Standard Utility Trailer #MPG475 will definitely work on a trailer like yours. The lower section is 45" long and will sit down in the trailer and attach to the floor/crossmembers with U-bolts. With…

view full answer...

Answer 10

Hello Cash, thanks for reaching out. You are needing an A-frame jack, correct? We do have a good option for you, but there is not anything specifically designed for tailgate clearance. That said, I recommend the following: - etrailer Electric Trailer…

view full answer...

Do the Etrailer Camper Jacks # TJ01RT-HD Come with Mounting/Installation Hardware?

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching