Total Extended Length of TJ01RT-HD Stabilizer Jack

Updated 07/09/2020 | Published 03/20/2015

Question:

Is the height measure meant of 21 3/4inch the length of the jack or from the floor straight up to the mounting plate? In the photo I need the measurement in red B Thank you for your help!

asked by: Danny

Expert Reply:

The fully extended length of the # TJ01RT-HD stabilizer jack would be 18 inches, which represents the 'A' Dimension in your photo. The 'B' dimension would simply be the height above the ground of the underside of your trailer when its level. The Atwood stabilizer jack is meant to hold up or stabilize the trailer, not lift it up off the ground.

expert reply by: Mike L

click to enlarge

Mark

7/6/2020

Is there any way to extend the length of the # TJ01RT-HD stabilizer jack ? After welding them in place, I added your trailer-raising kit & now the fully-extended jacks dont extend far enough when parked off-road. Thx!

Chris R.

7/9/2020

Are you asking if the Stabilizer Jacks # TJ01RT-HD can be extended past their 18" full extension height? Unfortunately there's nothing you can add to them to allow this. On really rough/unlevel terrain you could use some chocks or wooden blocks to help out.